Hoover Fridge Freezer Dynamic HNC 6200AE Instruction Manual
- June 6, 2024
- Hoover
Table of Contents
**
COMBINED AND FROST-FREE**
COMBINED
Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit on the back of the fridge compartment. In this case, turn the knob to lower settings.
FREEZING OF THE FREEZER COMPARTMENT
Place the foods to be frozen in the drawer. At the start of the freezing
process, so as not to make the fridge compartment excessively cold, it may be
necessary to turn the thermostat knob back, according to the load and room
temperature. Once the freezing process is completed, return the thermostat
knob to the usual value. The rating plate states the maximum quantity of foods
that can be frozen, (see figure 2).
DEFROSTING OF THE FREEZER COMPARTMENT
N.B.: For better air circulation, leave some room between the foodstuffs. In
the case of models with FROST FREE technology, avoid obstructing the cooling
air vents.
N.B.: To TEST consumption and preservation standards, remove all drawers
except for the bottom one.
REVERSING THE OPENING OF THE DOORS
Place the appliance on the floor or at a 45° angle, since it is necessary to work on the bottom of the appliance.
Remove the bottom hinge by loosening the screws, then remove the lower door.
| Remove the middle hinge by loosening the screws, then remove
the top door.
| Remove the bushes on the right-hand side of the doors and
mount them back on the left-hand side.
---|---|---
Remove the top hinge by loosening the screws. Unscrew the pin from the hinge.
| Disassemble and move the corner guide from the left to the
right-hand side, turning it 180°.
| Remount the hinges and doors working from bottom to top, 1 –
2 – 3. Also, remount the spacer washers between the door and hinge.
While fixing the top hinge on the left-hand side, tighten the screws and screw
the pin back on in the left hole.
| In order to reverse the vertical handles, if any, remove the
outer caps from the righthand side of the doors.
| Unscrew the handles from the left-hand side and move them to
the right-hand side, then position the outer caps removed previously from the
right-hand side to the left-hand side.
Put the appliance back in an upright position and wait two hours before
turning it on.
N.B. For the doors to be correctly aligned, it is necessary to operate on the
middle hinge.
Z STUDIO > 07-2009 Cod. 41032400
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>