Bradley 234-110000 Towel Dispenser and Waste Bin Combo Installation Guide
- September 4, 2024
- Bradley
Table of Contents
Bradley 234-110000 Towel Dispenser and Waste Bin Combo
Product Information
Specifications
- Model: 234
- Product Type: Towel Dispenser/Waste Receptacle
- Installation: Surface-Mounted Unit
- Manufacturer: COMMERCIAL SUPPLY
Product Usage Instructions
Installation
- Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring, etc. in the wall. Follow all applicable local building codes.
- If installing where the unit projects above the top of wainscot, provide aluminum channel or other filler to prevent a gap from the finished wall and flange of the unit. For block walls, use metal expansion shields (not included).
- Use suitable wall anchors (not included) for installation. If necessary, shim at anchor points to prevent distortion of the unit.
Rough-in Opening Dimensions
Ensure the rough-in opening dimensions are as follows:
- Top of Rough Wall Opening: 48 inches (1219 mm)
- Bottom of Rough Wall Opening: 12 inches (305 mm)
Contact Information
Contact COMMERCIAL SUPPLY for any further assistance or inquiries regarding
the installation or usage of Model 234.
FAQ
-
Q: Are the wall anchors included with the product?
A: No, suitable wall anchors are not included with the product and need to be sourced separately for installation. -
Q: What should be done if the unit projects above the top of wainscot during installation?
A: Provide aluminum channel or other filler to prevent a gap between the finished wall and the flange of the unit.
Installation
Model 234
Towel Dispenser/Waste Receptacle
Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring etc. in wall. Follow all applicable local building codes. If installing where unit projects above top of wainscot, provide aluminum channel or other filler to prevent gap from finished wall and flange of unit. For block walls, use metal expansion shields (not included).
Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring etc. in wall. Follow all applicable local building codes. If installing where unit projects above top of wainscot, provide aluminum channel or other filler to prevent gap from finished wall and flange of unit. For block walls, use metal expansion shields (not included).
Dim. “A” Key Surface:| For Dim. “A”| Top of Rough Wall Opening|
Bottom of Rough Wall Opening
---|---|---|---
Paper towel top of opening to finished floor| 48″ (1219)| 66¾” (1695)| 12″
(305)
45″ (1143)| 63¾” (1619)| 9″ (229)
42″ (1067)| 60¾” (1543)| 6″ (152)
40″ (1016)| 58¾” (1492)| 4″ (102)
Bradley Corporation • P20-138 Rev. C; ECM 11-15-025
BERLS.COM
704-937-2673
129 Oakpark Drive, Unit A, Mooresville, NC 28115
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>