Dynojet Benelli TNT 135 Power Commander-V Fuel Injection Module Installation Guide

June 3, 2024
Dynojet

POWER COMMANDER 6
Installation Guide for: PC6-37001
Model Coverage: 2016-2019 Benelli TNT135

PARTS LIST

1 POWER COMMANDER 6
1 INSTALLATION GUIDE
1 USB CABLE 2 DYNOJET DECALS
2 POWER COMMANDER DECALS
4 VELCRO STRIPS
1 ALCOHOL SWAB

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

IPC6-37001.01

INPUT ACCESSORY GUIDE

OPTIONAL ACCESSORY INPUTS

Map
(Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important.

Shifter
(Input 1 or 2) Used for clutch-less full throttle upshifts. Insert the wires from the Dynojet quick shifter into either Input 1 or Input 2. The polarity of the wires is not important. Set to Input 2 by default.

Speed
If your application has a speed sensor then you can tap into the signal side of the sensor and run a wire into this input. This will allow you to calculate gear position in the Control Center Software. Once gear position is setup you can alter your map based on gear position and setup gear dependent kill times when using a quick shifter.

Analog
This input is for a 0-5v signal such as engine temp, boost, etc. Once this input is established you can alter your fuel curve based on this input in the Power Core software.

Launch
You can connect a wire to either Input 1 or Input 2 and then the other end to a switch. This switch when engaged (continuity) will only allow the RPM to be raised to a certain limit (set in the software). When released, you will have full RPM.

WIRE CONNECTIONS
To input wires into the PC6 first remove the rubber plug on the backside of the unit and loosen the screw for the corresponding input. Using a 22-24 gauge wire, strip about 10mm from its end. Push the wire into the hole of the PC6 until it stops and then tighten the screw. Make sure to reinstall the rubber plug.
NOTE: If you tin the wires with solder it will make inserting them easier.

INSTALLING THE POWER COMMANDER 6

  1. Remove the seats.

  2. Unplug the stock BLACK connector from the bike’s ECM.

  3. Plug the PC6 wiring harness in-line of the ECM and the stock wiring harness.

  4. Secure the PC6 module to the top of the ECM with the supplied Velcro. Use the alcohol swab to clean surfaces before attaching the Velcro.

  5. Reinstall the seats. Download the latest map files from our web site at dynojet.com/tunes.

PUSH THE LIMIT

2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 –800-992-4993DYNOJET.COM
© 2004-2022 DYNOJET RESEARCH ALL RIGHTS RESERVED

Documents / Resources

| Dynojet Benelli TNT 135 Power Commander-V Fuel Injection Module [pdf] Installation Guide
Benelli TNT 135, Power Commander-V Fuel Injection Module, Fuel Injection Module, Power Commander-V Injection Module, Injection Module, Module
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals