Honeywell T87RF Single Zone Thermostat User Guide

June 6, 2024
Honeywell

Home
T87RF/Y87RF
Single Zone Thermostat
User Guide

Honeywell T87RF Single Zone Thermostat

Setting your room temperature

  1. Your current room temperature is shown in the display. To set the temperature you want, just turn the dial right to increase and left to decrease.
    Each ‘click’ as the dial turns represents a 0.5°C change.
    Honeywell T87RF Single Zone Thermostat -fig

  2. After five seconds the current room temperature will be displayed once again. The thermostat will then try to maintain your set temperature
    as accurately as possible.
    You can check your set temperature by turning the dial one ‘click’ to the left or right. The set temperature will flash up for a few seconds, before returning to display the room temperature again.
    Honeywell T87RF Single Zone Thermostat -fig2

Night-time temperature reduction

Overnight, or if you are out, it is best to set the thermostat to a lower temperature, as it will save you energy. In general, a reduction of 5°C is recommended, but this will depend on your heating system and the amount of insulation in your home.

Replacing the batteries

The batteries should be replaced when the symbol is displayed.
Remove the dial (1) and separate the thermostat (2) from the mounting plate (3). Replace the discharged batteries with two new AA alkaline batteries, then reattach the thermostat to the mounting plate and replace the dial.

Honeywell T87RF Single Zone Thermostat -fig1

Getting to know your display

Set Temperature Indicator
This means the figure on the screen is your set temperature, rather than your current room temperature.|
---|---
Heating on
This means there is a requirement for some heating, so your boiler should either be on or cycling on/off.|
Boiler Relay Connection
Means your thermostat is successfully connected to your Boiler Relay.|
Internet Gateway Connection (optional)
Means your thermostat is successfully connected to your Internet Gateway.|

Troubleshooting

Low batteries
If you see this battery icon then you need to replace the batteries right away.|
---|---
No power to the thermostat
If the thermostat screen is blank after initial installation, then check the protective tab has been removed from the batteries. Otherwise, try replacing the batteries.
RF communication error
If these icons are flashing, then there may be an issue with the signal from the Boiler Relay. The first check there is mains power to the Boiler Relay. If this does not resolve the problem, consult your installer.| Honeywell T87RF
Single Zone Thermostat -fiv
Defective thermostat
If this icon is displayed when the thermostat is no longer functioning and will need to be replaced.| Honeywell T87RF Single Zone Thermostat -fig
65

Binding your thermostat to an RFG100 Internet Gateway

If you want to be able to operate your Thermostat remotely or add scheduling then you will need to use the RFG100 Internet Gateway (sold separately) and bind the thermostat to it. To do this, please follow the full installation instructions in the RFG100 box, and at the relevant binding stage follow these steps to connect your thermostat:

  1. Touch and hold the right-hand touch zone for about 10 seconds to activate the binding screen.
    Honeywell T87RF Single Zone Thermostat -fig10

  2. Briefly touch the right-hand touch zone once again to send the binding signal. The and symbols will flash until the binding is successful.
    Honeywell T87RF Single Zone Thermostat -fig11

  3. With good reception, the green LED on the Gateway will then light up to confirm successful binding.
    Honeywell T87RF Single Zone Thermostat -fig 65

  4. After binding, the strength of the signal between the devices will appear on the thermostat for a few seconds. 1 equals the lowest strength and 5 the highest.
    Then the normal screen will be shown, including a symbol to confirm the Gateway and the thermostat are now connected.
    Honeywell T87RF Single Zone Thermostat -fig1 65

  5. Please refer to your Gateway instructions to learn how to create your online account and download our smartphone app.

Honeywell T87RF Single Zone Thermostat -fig52

For support:
Resideo
200 Berkshire Place
Winnersh Triangle, Berkshire
RG41 5R
Phone: 0300 130 1299

www.resideo.com

Pittway Sarl, Z.A. La Pièce 4,
1180 Rolle, Switzerland
Country of origin: UK
© 2020 Resideo Technologies, Inc. All rights reserved.
The Honeywell Home trademark is used under license from Honeywell International Inc.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Honeywell User Manuals

Related Manuals