motorola MBP75SN Care+ 3-in-1 Smart Non-Contact Baby Thermometer User Guide
- June 6, 2024
- Motorola
Table of Contents
CARE+ 3-in-1 smart non-contact baby thermometer
Model: MBP75SN
Quick Start Guide
For a full explanation of all features and instructions, please refer to the User’s Guide (available for download from www.motorolastore.com).
Setting up the 3-in-1 smart non-contact baby thermometer
-
The key to obtaining accurate readings is a clean sensor. To clean the sensor, use a cotton swab slightly moistened with alcohol to gently wipe its surface, and then immediately wipe dry using a clean cotton swab. Wait at least 20 minutes to make sure that the sensor is completely dry before taking temperature.
-
Skin surface lipids on the forehead may cause an inaccurate measurement, so make sure the forehead is clean. If you clean the forehead, please keep waiting a further 5 to 10 minutes before measuring.
-
If the temperature of the storage area differs greatly from that of the measuring area, please wait until the thermometer temperature has equalized to the room temperature, about 30 minutes, prior to use.
-
Gently remove the battery cover and install 2 x 1.5V AAA size alkaline batteries (which can be found inside the packaging) according to the proper polarity, slide the battery cover back, press the button to turn the thermometer on.
How to measure forehead temperature
Make sure the probe is clean before measuring.
-
Press the button to power on the thermometer. When the device is ready, ` – – ‘ will appear on the screen.
-
Ensure that the thermometer is in Forehead Mode; the Forehead symbol will be on the display.
-
Position the thermometer not more than 3cm (or 1 inch) from the center of the forehead with the sensor aimed between the eyebrows.
-
Press once the button, when the measurement is completed, it will end with a confirmation tone.
-
If the temperature measurement is below 380C/100.40F, a symbol will be appeared on display. If the reading is 380C/100.40F or above, symbol will be appeared on display.
-
About 30 seconds after use, the thermometer will automatically beep and shut off.
Note:
- High Temperature Alarm appears in both Forehead Mode and Forehead/Silent Mode. When taking a patient’s temperature, ensure that the thermometer is in Forehead Mode; the symbol appear on the display.
- If the skin is covered with hair, sweat, or dirt, clean the area and wait 10 minutes before taking a measurement.
- Ensure that the thermometer is held firmly during measurement and that the patient does not move until the measurement is completed, movement may impact the measurement.
Celsius/fahrenheit option
In standby mode, you can switch between Celsius (°C) and Fahrenheit (°F) by pressing and holding the Forehead/Object and Memory buttons at the same time.
Setting up the smart thermometer with the Hubble Connected App to track, save and share body temperature readings
A. Install Hubble Connected App.
- Scan the QR code with your smart device and download Hubble Connected App from the App Store for iOS devices or from the Google Play™ Store for Android™ devices.
- Install Hubble Connected App on your device.
B. Pair the Smart Thermometer with your AndroidTM Device/ iPhone®/iPad®.
- Open the Hubble Connected App on your compatible smartphone or tablet.
- Turn on Bluetooth on your compatible smartphone or tablet.
- Follow the in-app instructions to create your Hubble account and connect to your device.
Please take note of the following minimum system requirements:
Smartphones/Tablets: iOS 10.0, Android™ 7.0
General Information
If your product is not working properly, read this Quick Start Guide or the
User’s Guide.
Contact Customer Service:
Live Chat: motorolastore.support/en E-mail:
support@motorolastore.com
Consumer Products and Accessories Limited Warranty (“Warranty”)
Thank you for purchasing this Motorola branded product manufactured under
license by Binatone Electronics International Ltd. (“BINATONE”).
What Does This Warranty Cover?
Subject to the exclusions contained below, BINATONE warrants that this
Motorola branded product (“Product”) or certified accessory (“Accessory”) sold
for use with this product is manufactured to be free from defects in materials
and workmanship under normal consumer usage for the period outlined below.
This Warranty is your exclusive warranty and is not transferable.
Who Is covered?
This Warranty extends only to the first consumer purchaser, and is not
transferable.
What Will BINATONE Do?
BINATONE or its authorized distributor, at its option and within a
commercially reasonable time, will at no charge repair or replace any Products
or Accessories that does not conform to this Warranty.
We may use functionally equivalent reconditioned/refurbished/pre-owned or new
Products, Accessories or parts.
What Other Limitations Are There?
ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THE
DURATION OF THIS LIMITED WARRANTY, OTHERWISE THE REPAIR OR REPLACEMENTPROVIDED
UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER,
AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED.
IN NO EVENT SHALL MOTOROLA OR BINATONE BE LIABLE, WHETHER IN CONTRACT OR TORT
(INCLUDING NEGLIGENCE) FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE
PRODUCT OR ACCESSORY, OR FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES OF ANY KIND, OR LOSS OF REVENUE OR PROFITS, LOSS OF
BUSINESS, LOSS OF INFORMATION OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN
CONNECTION WITH THE ABILITY OR INABILITY TO USE THE PRODUCTS OR ACCESSORIES TO
THE FULL EXTENT THESE DAMAGES MAY BE DISCLAIMED BY LAW.
Some jurisdictions do not allow the limitation or exclusion of incidental or
consequential damages, or limitation on the length of an implied warranty, so
the above limitations or exclusions may not apply to you. This Warranty gives
you specific legal rights, and you may also have other rights that vary from
one jurisdiction to another.
| Products Covered | Length of Coverage |
|---|---|
| Consumer Products | One (1) year from the date of the products, original |
purchase by the first consumer purchaser of the product.
Consumer Accessories| Ninety (90) days from the date of the Accessories,
original purchase by the first consumer purchaser of the product.
Consumer Products and Accessories that are Repaired or Replaced| The balance
of the original warranty or for Ninety (90) days from the date returned to the
consumer, whichever is longer.
Exclusions
Normal Wear and Tear. Periodic maintenance, repair and replacement of
parts due to normal wear and tear are excluded from coverage.
Batteries. Only batteries whose fully charged capacity falls below 80% of
their rated capacity and batteries that leak are covered by this Warranty.
Abuse & Misuse. Defects or damage that result from: (a) improper
operation, storage, misuse or abuse, accident or neglect, such as physical
damage (cracks, scratches, etc.) to the surface of the product resulting from
misuse; (b) contact with liquid, water, rain, extreme humidity or heavy
perspiration, sand, dirt or the like, extreme heat, or food; (c) use of the
Products or Accessories for commercial purposes or subjecting the Product or
Accessory to abnormal usage or conditions; or (d) other acts which are not the
fault of MOTOROLA or BINATONE, are excluded from coverage.
Use of Non-Motorola branded Products and Accessories. Defects or damage that
result from the use of Non-Motorola branded or certified Products or
Accessories or other peripheral equipment are excluded from coverage.
Unauthorized Service or Modification. Defects or damages resulting from
service, testing, adjustment, installation, maintenance, alteration, or
modification in any way by someone other than MOTOROLA, BINATONE or its
authorized service centers, are excluded from coverage.
Altered Products. Products or Accessories with (a) serial numbers or date
tags that have been removed, altered or obliterated; (b) broken seals or that
show evidence of tampering; (c) mismatched board serial numbers; or (d) non-
conforming or nonMotorola branded housings, or parts, are excluded from
coverage.
Communication Services. Defects, damages, or the failure of Products or
Accessories due to any communication service or signal you may subscribe to or
use with the Products or Accessories is excluded from coverage.
How to Obtain Warranty Service or Other Information ?
To obtain service or information, please call:
ULive Chat: motorolastore.support/en E-mail: support@motorolastore.com You will receive instructions on how to ship the Products or Accessories at your expense and risk, to a BINATONE Authorised Repair Center. To obtain service, you must include: (a) the Product or Accessory; (b) the original proof of purchase (receipt) which includes the date, place and seller of the Product; (c) if a warranty card was included in your box, a completed warranty card showing the serial number of the Product; (d) a written description of the problem; and, most importantly; (e) your address and telephone number.
These terms and conditions constitute the complete warranty agreement between you and BINATONE regarding the Products or Accessories purchased by you, and supersede any prior agreement or representations, including representations made in any literature publications or promotional materials issued by BINATONE or representations made by any agent, employee or staff of BINATONE, that may have been made in connection with the said purchase.
Disposal of the Device (Environment)
At the end of the product life cycle, you should not dispose of this product
with normal household waste. Take this product to a collection point for the
recycling of electrical and electronic equipment. The symbol on the product,
user’s guide and/or box indicates this obligation. By taking end-of-life
products to a recycling point, you are ensuring that some of the product
materials can be re-used. By reusing some parts or raw materials from used
products, you make an important contribution to the protection of the
environment. Please contact your local authorities should you require
additional information on the collection points in your area.
IMPORTANT INFORMATION REGARDING ELECTROMAGNETIC COMPATIBILITY(EMC)
With the increased number of electronic devices such as PC’s and mobile
(cellular) telephones, medical devices in use may be susceptible to
electromagnetic interference from other devices. Electromagnetic interference
may result in incorrect operation of the medical device and create a
potentially unsafe situation. Medical devices should also not interfere with
other devices.
In order to regulate the requirements for EMC (Electro Magnetic Compatibility) with the aim to prevent unsafe product situations, the IEC 60601-1-2:2014 standard has been implemented. This standard defines the levels of immunity to electromagnetic interferences as well as maximum levels of electromagnetic emissions for medical devices. Medical devices manufactured by AViTA Corporation. conform to this IEC 60601-1-2:2014 standard for both immunity and emissions. Nevertheless, special precautions need to be observed: The use of accessories and cables other than those specified by manufacturer, with the exception of cables sold by manufacturer as replacement parts for internal components, may result in increased emission or decreased immunity of the device.
- The medical devices should not be used adjacent to or stacked with other equipment. In case adjacent or stacked use is necessary, the medical device should be observed to verify normal operation in the configuration in which it will be used.
- Refer to further guidance below regarding the EMC environment in which the device should be used.
FCC AND IC REGULATIONS (FCC PART 15)
Warning: Changes or modifications to this equipment not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Industry Canada. This device complies with the Industry Canada license-exempt
RSS standard(s):
Operation is subject to the following Two conditions:(1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Model name: NT11
USA & Canada: MBP75SN
Standard Specification for Infrared Thermometer: ASTM E 1965-98: 2016
China Manufacturing License(s): SSYJXSCX20040018
Registration Certificate(s): SXZZ20182200808
Manufacturer: AViTA (WuJiang) Co.LTD.
Add.: No. 858, Jiao Tong Rd., Wujiang Economic Development Zone, Suzhou City ,
Jiangsu Province, P.R.C. Tel: +86-512-8207-8288 Made in China
Download User Guide from website:
www.motorolastore.com/support
Manufactured, distributed or sold by Binatone Electronics International LTD., official licensee for this product. MOTOROLA and the Stylized M logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC. and are used under license. All other trademarks are the property of their respective owners. © 2020 Motorola Mobility LLC. All rights reserved.
Printed in China Version 1.0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>