HENDI 3000 M Induction Cooker User Manual

: June 6, 2024
: HENDI

Table of Contents

Safety regulations
Special Safety Regulations
Intended use
Grounding installation
Control panel of the appliance
Operation
Error codes display
Cleaning and Maintenance
Troubleshooting
Technical specification
Warranty
Documents / Resources

Induction cooker
model 3000 M / 3500 M
239315, 239780

HENDI 3000 M Induction Cooker

You should read this user manual carefully before using the appliance.
Keep these instructions with the appliance.
For indoor use only.

HENDI 3000 M Induction Cooker - icon3

Dear Customer,
Thank you for purchasing this Hendi appliance. Before using the appliance for the first time, please read this manual carefully, paying particular attention to the safety regulations outlined below.

Safety regulations

This appliance is intended for commercial use.
The appliance must only be used for the purpose for which it was intended and The manufacturer is not liable for any damage caused by incorrect operation and improper use.
Keep the appliance and electrical plug away from water and any other liquids. In the event that the appliance should fall into the water, immediately remove the plug from the socket and do not use it until the appliance has been checked by a certified technician. Failure to follow these instructions could cause a risk to
Never attempt to open the casing of the appliance yourself.
Do not insert any objects in the casing of the appliance.
Do not touch the plug with wet or damp hands.
The danger of electric shock! Do not attempt to repair the appliance In case of malfunctions, repairs are to be conducted by qualified personnel only.
Never use a damaged appliance! Disconnect the appliance from the electrical outlet and contact the retailer if it is damaged.
Warning! Do not immerse the electrical parts of the appliance in water or other I Never hold the appliance under running water.
Regularly check the power plug and cord for any If the power plug or power cord is damaged, it must be replaced by a service agent or similarly qualified persons in order to avoid danger or injury.
Make sure the cord does not come in contact with sharp or hot objects and keep it away from open To pull the plug out of the socket, always pull on the plug and not on the cord.
Ensure that the cord (or extension cord) is positioned so that it will not cause a trip hazard.
Always keep an eye on the appliance when in
Warning! As long as the plug is in the socket the appliance is connected to the power
Turn off the appliance before pulling the plug out of the socket.
Never carry the appliance by the
Do not use any extra devices that are not supplied along with the appliance.
Only connect the appliance to an electrical outlet with the voltage and frequency mentioned on the appliance label.
Connect the power plug to an easily accessible electrical outlet so that in case of emergency the appliance can be unplugged To completely switch off the appliance pull the power plug out of the electrical outlet.
Always turn the appliance off before disconnecting the
Never use accessories other than those recommended by the manufacturer. Failure to do so could pose a safety risk to the user and could damage the appliance. Only use original parts and accessories.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge.
This appliance must not be used by children under any circumstances.
Keep the appliance and its cord out of reach of
Always disconnect the appliance from the mains if it is left unattended or is not in use, and before assembly, disassembly or
Never leave the appliance unattended during use.

Special Safety Regulations

This appliance is designed for cooking a variety of food via heating the cookware. Any other use may lead to damage of the appliance or personal
Use the appliance only as described in this manual.
This appliance should be operated by trained personnel in the kitchen of the restaurant, canteens or bar staff, etc.
Caution! The danger of burns! The temperature of the heating surface and other accessible surfaces is very high during use. Touch the control panel only.
Caution! This appliance will emit non-ionizing electromagnetic radiation.
Do not place the appliance near objects that may be affected by a magnetic field such as TVs, radios, bank cards, and credit cards.
Do not place the appliance on a heating object (gasoline, electric, charcoal cooker, etc.) Keep the appliance away from any hot surfaces and open flames. Always operate the appliance on a level, stable, clean, heat-resistant, and dry
Make sure the appliance is not placed near water vapor or greasy vapors. The fan inside of the appliance will take in these vapors and this will cause grease or moisture to accumulate in the appliance which may result in a short-circuit in the appliance.
Do not use the appliance near explosive or flammable materials, credit cards, magnetic discs, or radios.
This appliance is not intended to be operated by means of an external timer or separate remote-control system.
Metallic objects such as knives, forks, spoons, and lids should not be placed on the heating plate since they can get hot.
WARNING: Keep all ventilation openings in the appliance clear of
WARNING: If the heating surface is cracked or damaged, switch off the appliance to avoid the possibility of electric shock.
Allow at least 15 cm spacing around the appliance for ventilation purposes during use.
Do not use hard utensils to hit the heating plate surface. Do not use a water jet, flush directly with water or steam cleaner as the parts will get wet and electric shock might be
Take care when operating the appliance, like rings, watches, and similar objects worn by the user could get hot when in close proximity to the heating
Caution! Securely route the power cord if necessary in order to prevent unintentional pulling or contact with the heating
Do not wash the appliance with Washing can cause leakages and increase the risk of electric shock.
Do not clean or store the appliance unless it is completely cooled down.
Do not place empty cookware on the appliance during operation as this may damage the
Only use the cookware of the type and size (See —> Suitable cooking equipment].

Intended use

This appliance is intended for professional use.
The appliance is designed only for cooking a variety of food via heating the suitable cookware. Any other use may lead to damage to the appliance or personal injury.
Operating the appliance for any other purpose shall be deemed as a misuse of the device. The user shall be solely liable for improper use of the device.

Grounding installation

This appliance is classified as a protection class I appliance and must be connected to protective ground. Grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.

Control panel of the appliance

HENDI 3000 M Induction Cooker - Control

Digital display: Display ON, OFF, and power settings.
Turning knob: Switch ON/OFF and power setting

Preparations before using for the first time

Remove all protective packaging and wrapping.
Check to make sure the appliance is undamaged. In case of incomplete delivery and damages. Please contact the supplier (See > Warranty).
Clean the appliance before use (See > Clean-ing and Maintenance).
Make sure the appliance is completely dry.
Place the appliance on a horizontal, stable, and heat-resistant surface that is safe against water splashes.
Ensure that there is sufficient ventilation. Keep a minimum distance of 15cm around the appliance bottom of the cookware
Do not place the appliance in close proximity to devices that are sensitive to disturbances by magnetic sources (e.g. radios, tape decks).

Note: Due to manufacturing residues, the appliance may emit a slight odor in the first few cycles. This is normal and does not indicate any defect or hazard. Make sure the appliance is well ventilated.

Suitable cooking equipment

| Suitable|

Not suitable

---|---|---
Bottom of cookware|

Flat bottom HENDI 3000 M Induction Cooker - fig1

|

Curved, uneven, rounded bottom HENDI 3000 M Induction Cooker -
fig2

Material| Cookware with iron, cast iron, magnetic stainless steel, or enameled iron bottom.| Cookware with ceramic, glass, copper, bronze, or aluminum bottom.
Diameter of the bottom| Between 12 cm and 26 cm.| Less than 12 cm or more than 26 cm.
Type of cookware| Cookware with a bottom thickness over 1.5 mm.| Completely closed containers or cans.

Note: Using a pan or pot that’s not suitable for induction cooking may damage the appliance.

Operation

Place suitable cookware at the center of the heating surface of the appliance. (See –> Suitable cookware for the appliance).
Note: Do not place empty cookware as this may damage the cookware.
Connect the power plug to a suitable electrical supply outlet.
Then, switch ON the appliance by turning the knob (2) in a clockwise direction.
“ON” will be shown instantly on the display (1).
Next, choose the power level by turning the knob (2)
The minimal setting is 500W which increases in steps of 100 W to the maximum setting of 3500 W for item 239780 or 3000W for item 239315.
Now, the appliance starts heating operation. The set power will be shown on the display (1) during
After cooking is finished, you can turn off the appliance at any time by turning the knob (2) anti-clockwise. “OFF” will be shown on the display (1) for few seconds and then go off.

Note:

After an extended period of operation, it is normal for the cooling fan inside to continue running in OFF mode for some time. Before unplugging the appliance, wait until the cooling fan stops running.
The appliance’s surface is still hot even after switching to OFF mode. Please wait for the appliance to completely cool down before touching or clean
If no cookware is placed on the heating surface after switch ON, it will turn to OFF mode automatically within 1 min.
If no button on the control panel is pressed during operation for 2 hours, the appliance will then switch to OFF mode automatically.
If the appliance beeps after being switched on, the pan you are using is not suitable for induction or the appliance is defective. In case of any doubt, always contact the supplier of your pan!

Error codes display

Error codes are shown on the display (1)

| Possible cause|

Possible solution

---|---|---
E01| The temperature of the appliance is too high| Unplug the appliance, remove the cookware, wait until the appliance is completely cool down.
Cooling fan defective| Contact the supplier.
E02| The temperature of the cookware is too high. Possibly, the cookware becomes empty and the appliance will shut down for protection.| Unplug the appliance, remove the cookware, wait until the appliance is completely cool down.
E03| The supply voltage is abnormal. (Supply voltage is too high or too low)| Make sure that the appliance is connected to a suitable electrical power supply.

Cleaning and Maintenance

Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before cleaning and storage.
Cleaning

Never immerse the appliance in water or other liquids.
Clean the cooled exterior surface with a slightly damp cloth or sponge with some mild soap solution.
Never use abrasive sponges or detergents, steel wool, or metallic utensils to clean the interior or exterior parts of the appliance.

Storage

Before storage, always make sure the appliance has already been disconnected from the electrical outlet and cooled down completely.
Store the appliance in a cool, clean, and dry place.
Never put heavy objects on the heating surface during storage as they may crack it.

Troubleshooting

If the appliance does not function properly, please check the below table for the solution. If you are still unable to solve the problem, please contact the supplier/service provider.

Error codes are shown on the digital display (1). (See –> Error codes display)

Problems

| Possible cause|

Possible solution

---|---|---
The appliance does not switch ON.| – Power plug is not connected properly with the electrical outlet.
– Without switch ON the appliance by turn ON the knob.| – Check the power plug to make sure it is connected properly.
– Switch ON the appliance by turning ON the knob.
The cooling fan is operating even after the appliance is switched to OFF mode.| – This is normal. The cooling fan continues running in Standby mode for some time to cool down all internal elements.| – Wait until the cooling fan stops rotating.

Technical specification

Item no	239315	239780
Operating voltage and frequency

220- 240W 50/60Hz

Class I

Waterproof protection class|

IPX3

Dimension| 327x420x(H)100mm| 327x425x(H)100mm

Remark: Technical specification is subjected to change without prior notification

Warranty

Any defect affecting the functionality of the appliance which becomes apparent within one year after purchase will be repaired by free repair or replacement provided the appliance has been used and maintained in accordance with the instructions and has not been abused or misused in any way. Your statutory rights are not affected. If the appliance is claimed under warranty, a state where and when it was purchased and include proof of purchase (e.g. receipt).
In line with our policy of continuous product development, we reserve the right to change the product, packaging, and documentation specifications without notice.
Discarding & Environment
When decommissioning the appliance, the product must not be disposed of with other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point. Failure to follow this rule may be penalized in accordance with applicable regulations on waste disposal. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste for recycling, please contact your local waste collection company. The manufacturers and importers do not take responsibility for recycling, treatment, and ecological disposal, either directly or through a public system.

Hendi B.V.
Steenoven 21
3911 TX Rhenen, The Netherlands
Tel:+31 (0)317 681 040
Email: info@hendi.eu
PKS Hendi South East Europe SA
5 Metsovou Str.
18346 Moschato, Athens, Greece
Tel: +30 210 4839700
Email: office.greece@hendi.eu
Hendi HK Ltd.
1208, 12/F Exchange Tower
33 Wang Chiu Road, Kowloon Bay, Hong Kong
Tel: +852 2154 2618
Email: info-hk@hendi.eu
Hendi Food Service Equipment Romania Srl
Str. 13 decembrie 94A, Hala 14
Brașov, 500164, Romania
Tel: +40 268 320330
Email: office@hendi.ro
Find Hendi on internet:
www.hendi.eu
www.facebook.com/HendiToolsforChefs
www.linkedin.com/company/hendi-food-service- equipment-b.v.
www.youtube.com/HendiEquipment
– Changes, printing, and typesetting errors reserved.
© 2020 Hendi BV Rhenen – The Netherlands
Ver: 28-08-2020