V-TAC VTST15 LED Lamp Instruction Manual

V-TAC VTST15 LED Lamp

Installation

Installation A: Wall Mounted

1. Prepare lamp, accessories and tools well firstly.
2. Insert the L-shaped bracket into the socket. (Figure 1)
3. Use allen wrench to tighten the cap screws. (Figure 2)
4. According to demanded installation height, drill 2 holes of φ8mm with a depth of at least 60mm on the wall, and fix the expansion screws into the holes. Then use a wrench to fix the light fixture. (Figure 3)

Installation B: Lamp-post Mounted

1. Prepare lamp, accessories and tools well firstly.
2. Open the cover of lamp socket. (Figure 1)
3. Fix the lamp-post fixture onto the lamp socket (do not lock first). (Figure 2)
4. Set up the lamp onto the lamp-post. (Figure 3)
5. Adjust the lamp parallelly and lock the lamp-post fixture. (Figure 4)

Warning!

1. The lamp is equipped with an internal battery pack, which is replaceable.
   If any need, please contact seller for correct new battery pack.

2. Non-professionals please do not disassemble the lamp.

3. Please do not dispose the battery with household garbage to avoid explosion.

Specification

Features

Working Mode

Automatically turns on to full brightness(1600lm) when motion is detected in the range ≤ 8mtrs and then turns to 3% brightness in 20 seconds of no motion, then turns off after 5 minutes.

Notice

1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather.
3. Built-in intelligent IC with over-charge, over-discharge and over-voltage protection.
4. The lamp will light up automatically at dusk.

Applications

• This lamp can be used as wall light and street light, multi-funcational.
• You can easily install it in garden, garage, pathway, street, entrance, courtyard, square etc.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>