PERUN AL C20C C20 Li-ion Battery Charger Kit and Charging Station Instruction Manual
- June 6, 2024
- PERUN
Table of Contents
PERUN AL C20C C20 Li-ion Battery Charger Kit and Charging Station
SYMBOLS
Safety symbols
The purpose of safety symbols is to attract your attention to any possible
dangers. The safety symbols and their explanations deserve your careful
attention and full understanding. The symbol warnings do not, by themselves,
eliminate any danger. The instructions and warnings they give are no
substitute for proper accident prevention measures.
WARNING: Be sure to read and understand all safety instructions within
this operator’s manual, including all safety alert symbols such as “DANGER”,
“WARNING”, and “CAUTION” before using this tool. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAFETY ALERT SYMBOLS: Indicate DANGER, WARNING, or CAUTION. May be used
in conjunction with other symbols or pictographs.
Symbol meanings
This page depicts and describes safety symbols that may appear on this
product. Read, fully understand and follow all instructions on the machine
before attempting to assemble and operate.
GENERAL SAFETY WARNINGS
Read all safety warnings and all instructions. Fail- ure to follow the
warnings and instructions may result in electric shock, fire and/or serious
injury.
Save these instructions for later use.
Use the battery charger only when you fully understand and can perform all
functions without limitation, or have re- ceived appropriate instructions.
- Only charge PERUN lithium-ion batteries. The battery voltage must match the battery charging voltage of the charger. Otherwise there is danger of fire and explosion.
- Keep the battery charger clean. Contamination can lead to danger of an electric shock.
- Before each use, check the battery charger, cable and plug. If damage is detected, do not use the battery charger. Never open the battery charger yourself. Have repairs performed only by a qualified technician and only using original spare parts. Damaged battery chargers, ca- bles and plugs increase the risk of an electric shock.
- Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the charger. Keep cord away from heat, oil, sharp edges and moving parts. Damaged or en- tangled cords increase the risk of electric shock.
- Do not operate the battery charger on easily inflammable surfaces (e. g., paper, textiles, etc.) or surroundings. The heating of the battery charger during the charging process can pose a fire hazard.
- In case of damage and improper use of the battery, vapours may be emitted. Ventilate the area and seek medical help in case of complaints. The vapours can irritate the respiratory system.
- Supervise children during use, cleaning and maintenance. This will ensure that children do not play with the charger.
- This tool is not intended for use by persons (including children) with reduced physical, sensory or mental ca- pabilities, or lack of experience and knowledge, unless they have been given supervision or instruction con- cerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
- Cleaning and user maintenance of the battery charger shall not be made by children without supervision.
- Do not cover off the battery charger. Otherwise, the battery charger can overheat and no longer operate properly.
- In addition, observe the safety instructions for the battery.
- This is a class I unit and may only be connected to properly earthed power sources.
Products sold in GB only: Your prod- uct is fitted with a BS 1363/A approved
electric plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be cut off and
an appropriate plug fitted in its place by an authorised customer service
agent. The replacement plug should have the same fuse rating as the original
plug. The severed plug must be disposed of to avoid a possible shock hazard
and should never be inserted into a mains socket elsewhere.
INTENDED USE
The contained charger is intended for use with PERUN battery pack.
TECHNICAL DATA
| Battery charger Model | AL C20C |
|---|---|
| Input | 220-240 V ～, 50/60 Hz 65 W |
| Output | 20 V __ , 2.4 A |
| Protection class | II |
OPERATION
Charging the battery pack
NOTE:
- Remove the battery pack from the charger after it has been fully charged.
- Battery should be fully charged before first use.
- Make sure the mains voltage is the same as rating label which is located on the charger.
- Connect the charger to a power supply. The red LED will light up.
- To insert the battery pack into the charger, align the raised ribs of the battery pack with the grooves of the charger then push it in.
- The green LED light of the charger will flash continuously during normal charging.
- After charging is complete, the green LED will light
MAINTENANCE AND STORAGE
Maintenance and Cleaning
Occasionally clean the battery using a soft, clean and dry brush.
Disposal
Battery chargers, accessories and packaging should be sorted for
environmental-friendly recycling.
Do not dispose of battery chargers into household waste!
Only for EC countries:
According to the European Guideline 2012/19/EU for Waste Electrical and
Electronic Equipment and its implementation into national right, battery
chargers that are no longer usable must be collected separately and disposed
of in an environmental correct manner.
CE DECLARATION
To the provisions of Council Directives
We MEROTEC GmbH
Otto-Brenner-Str. 8
47877 Willich, Germany
Declare that the product:
Machine Description: 20V Charger
AL C20C/ B0Q-SP06-20ZA
Function: Charging battery
Complies with the essential health and safety requirements of the following
directives:
Low Voltage Directive 2014/35/EU
Electromagnetic Compatibility Directive 2014/30/EU
EC Directive 2011/65/EU and its amendment Directive (EU) 2015/863 (RoHS)
Standards and technical specification referred to :
60335-1: 2012+A11+A13 EN 60335-2-29: 2004+A2+A11
55014-1: 2017 EN 55014-2: 2015
61000-3-2: 2014 EN 61000-3-3: 2013
50581: 2012 EN62233: 2008
Authorized Signatory
Date: 24.03.2020
Signature:____
Place: Willich
Name: Roland Menken
General Manager
The object of the declaration described above satisfies the provisions of
directive 2011/65/EU of the European Parliament and the Council of 8 June 2011
on limiting the use of certain harmful substances in electrical and electronic
appliances.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>