apuro CY140-A Blender Instruction Manual

: June 6, 2024
: apuro

Table of Contents

Safety Tips
Introduction
Product Description
Pack Contents
Operation
Using the timer function
Cleaning, Care & Maintenance
Troubleshooting
Technical Specifications
Electrical Wiring
Compliance
DECLARATION OF CONFORMITY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Blender
Instruction manual

apuro CY140-A Blender

Model:
CY140-A / CY141-A

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
Consult Local and National Standards to comply with the following:
– Health and Safety at Work Legislation
– Fire Precautions
– Wiring Regulations
– Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT immerse the appliance in water.
This appliance is only used for blending food. Do not use the appliance for anything other than its intended use.
Always switch off and disconnect the power supply to the appliance when not in use.
Not suitable for outdoor use.
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
If the power cord is damaged, it must be replaced by an Apuro agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
Keep hands and utensils out of the jug while the motor is running to prevent severe personal injury and/or damage to the blender.
The blade is sharp – handle carefully.
Never try to remove the blade while the jug is sitting on the blender base.
Do not operate with loose or damaged blades.
Always operate with the lid in place.
Do Not blend Hot Liquids.
Do not leave blender unattended while in use.
Apuro recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity, and Functional Testing.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Apuro product.

Product Description

CY140-A – Apuro Blender with Touch Control – 2.5Ltr Jug
CY141-A – Apuro Blender with Touch Control – 2.5Ltr Jug – with Sound Enclosure

Pack Contents

The following is included:

Apuro Blender
Blender Jug, lid and lid plug
Food pusher
Instruction manual

Apuro prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your Apuro dealer immediately.

Operation

apuro CY140-A Blender -fig

Blending

| Before use, ensure to:

Disconnect the blender from the power supply.
Clean all removable parts thoroughly.

---|---

Plugin Blender.
Place ingredients into a jug.
Secure the lid and lid plug (Note: Always operate with the lid secured).
Locate jug on to the body of the blender. The On/Off key lights up.
Press the On/Off key to enter standby. Press again to start blending with the default speed setting (2).
Pulse function: Press and hold the Pulse key to start. Release to stop.
After use, press the On/Off key to switch off the blender.

Using the timer function

If to use the timer function during use:

Press the desired time key. Then press the speed key or On/Off key .
The blender starts while the timer counts down on the display.
When the set time expires, the blender switches off automatically.

During use, you can press the time/speed key to pause the operation. Press again to continue.

| Note:

When blending dry ingredients best results will be obtained by cutting ingredients into small pieces and adding them to the blender through the hole in the lid when the motor is running.
Before removing the jug, ensure to turn off the blender using the On/Off switch and let the motor come to a complete stop.

---|---

Cleaning, Care & Maintenance

Always disconnect from the power supply before cleaning.
Always allow cooling before cleaning.
Let the motor come to a complete stop before removing the jug.
The jug is NOT dishwasher proof!
Use warm, soapy water and a damp cloth to clean the jug.
Warning: Blade is sharp – handle with care.
Dry thoroughly after cleaning.
An Apuro dealer or qualified technician should carry out repairs if required.

Warning: Do not allow any water to spill into the body of the appliance when cleaning.

Troubleshooting

Fault

| Probable Cause|

Solution

---|---|---
The unit is not working| The unit is not switched on| Check the unit is plugged in correctly and switched on
Plug and lead are damaged| Call Apuro agent or qualified Technician
Power supply| Check power supply
Internal wiring fault| Call Apuro agent or qualified technician
Jug incorrectly located on the body of the appliance| Relocate Jug

Technical Specifications

Model| Voltage| Power| Current| lug| | Dimensions
h x w x d mm| Weight
---|---|---|---|---|---|---|---
| | | | Capacity
CY140-A| 220-240V—| 1680W| 8A| 2.5L| 535 x 236 x 253| 6kg
| 50-60Hz| | | | |
CY141 – A| 220-240V— 50-60Hz| 1680W| 8A| 2.5L| 547 x 236 x 253| 9kg

Electrical Wiring

The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:

Live wire (colored brown) to the terminal marked L
Neutral wire (colored blue) to the terminal marked N
Earth wire (colored green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency, disconnection is required they must be readily accessible.

Compliance

The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
Apuro parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
Apuro products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Apuro.
Every effort is made to ensure all details are correct at the time of going to press, however, Apuro reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

Conformiteitsverklaring

Equipment Type

|

Model

---|---
Blender with touch control – 2.5Ltr Jug
Blender with touch control – 2.5Ltr Jug – with Sound Enclosure| CY140-A

CY141-A

Application of Territory Legislation &
Council Directives(s)
Toepassing van Europese Richtlijn(en)| Electrical safety
EN 60204-1:2018
EN 12852:2001 +A1:2010
EN ISO 12100:2010
Electro-Magnetic Compatibility
EN 55014-1: 2017
EN 55014-2: 2015
EN 61000-3-2: 2014
EN 61000-3-3: 2013

Producer Name

|

Apuro

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s)
and Standard(s).