AMADA AMPS01 Projector Tripod Stand Instruction Manual

: June 6, 2024
: AMADA

Table of Contents

Speciﬁcation
IMPORTANT SAFETY INFORMATION
Supplied Parts and Hardware
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Tripod Stand Instruction Manual AMADA AMPS01 Projector Tripod Stand
-figure 1

Model: AMPS01/AMPS01K

Thank you for choosing this AMADA product! At AMADA we strive to provide you with the best quality products and services in the industry. Should you have any issues, please don’t hesitate to contact us at amada_supportus@163.com(US/CA)

Speciﬁcation

IMPORTANT SAFETY INFORMATION

Check package contents against supplied parts and hardware list to assure that all components were received undamaged. Do not use damaged or
defective parts. if you require replacement parts, please contact Amanda customer service at amada_supportus@163.com.
Carefully read all instructions before attempting installation. If you do not understand the instructions or have any concerns or questions, please contact customer service at amada_supportus@163.com.
Not all parts and hardware included will be used.
Do not use this product for any purpose that is not explicitly speciﬁed in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by incorrect assembly or inappropriate use. Thank you for your understanding.

Supplied Parts and Hardware

Step 1 Secure Tray Support Leg into Tripod Stand

|
---|---

Step 2 Secure the Metal Clamps into the Middle of the Rubber Grips

Step 3 Secure the Tray to the Metal Clamps Note:

The holes in the metal clamp should be aligned with the holes on the tray.
Do not tighten the bolts [F] until all of them are in the right positions.

Step 4 Adjust the Tilt Angle and the Height

AMADA AMPS01 Projector Tripod Stand -figure 8

Tilt Adjustment of Tray
Slightly loosen the tilt adjustment knobs [T] for better adjusting the height. When you adjust the tray to your desired tilt angle, tighten the knobs [T] to secure the height in place.
Height Adjustment of Tray Support Leg

Remove the safety pin [S] from the tray support leg.
Slightly loosen the height adjustment knob [H1] for better adjusting the height.
When you adjust the tray support leg to your desired height, tighten the knob [H1] and insert the safety pin [S] into the hole of the tray support leg.

Height Adjustment of Tripod Stand

Slightly loosen the height adjustment knob [H2] for better adjusting the height of the tripod stand.
When you adjust the tripod stand to your desired height, tighten the knob [H2] to secure the height in place.