AMADA AMPS02 Tall Projector Tripod Stand Instruction Manual

Tripod Stand Instruction Manual
V1.0(B)

Model: AMPS02

AMPS02 Tall Projector Tripod Stand

Thank you for choosing this AMADA product! At AMADA we strive to provide you with the best quality products and services in the industry. Should you have any issues, please don’t hesitate to contact us at [email protected]

Specification

IMPORTANT SAFETY INFORMATION

• Check package contents against supplied parts and hardware list to assure that all components were received undamaged. Do not use damaged or defective parts. lf you require replacement parts, please contact amada customer service at [email protected].
• Carefully read all instructions before attempting installation. If you do not understand the instructions or have any concerns or questions, please contact customer service at [email protected].
• Not all parts and hardware included will be used.
• Do not use this product for any purpose that is not explicitly specified in this manual. We cannot be liable for damage or injury caused by incorrect assembly or inappropriate use. Thank you for your understanding.

Supplied Parts and Hardware

Step 1: Adjust the Height of the Tripod

Warning: When you unfold or fold the tripod, please be careful and avoid pinch areas such as the upper section of the supporting leg. DO NOT place hands on or near the joints of the supporting leg.

When you adjust the pillar to your desired height, tighten the knob, then insert the safety pin into the hole on the pillar.

Step 2: Secure the Connector to the Top of the Tray Support Leg

Step 3: Secure the Tray to the Connector

Note:

• The holes in the connector should be aligned with the holes on the tray.
• Do not tighten the bolts [D] until all of them are in right positions.

Step 4: Tilt and Height Adjustment

Tilt Adjustment of Tray
Slightly loosen the tilt adjustment knobs [K] for better to adjust the height. When you adjust the tray to your desired tilt angle, tighten the knobs [K] to secure the height in place.

Height Adjustment of Tray Support Leg

1. Remove the safety pin [M] from the tray support leg.
2. Slightly loosen the height adjustment knob [N] for better to adjust the height.
3. When you adjust the tray support leg to your desired height, tighten the knob [N] and insert the safety pin [M] into the hole of the tray support leg.

Height Adjustment of Tripod Stand

1. Slightly loosen the height adjustment knob [O] for better to adjust the height of the tripod stand.
2. When you adjust the tripod stand to your desired height, tighten the knob [O] to secure the height in place.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>