AMADA AMPS05 Projector Stand with Wheels Laptop Tripod Stand Instruction Manual

AMADA AMPS05 Projector Stand with Wheels Laptop Tripod Stand

Dimension

IMPORTANT SAFETY INFORMATION

• Check package contents against supplied parts and hardware list to ensure that all components were received and undamaged. DO NOT use damaged or defective parts. If you require replacement parts, please contact technical support at 877-200-3259 (US/CA) / 44-808-178-0934 (UK) or customer service at support@amadahome.com.
• Carefully read all instructions before attempting installation. If you DO NOT under­stand the instructions or have any questions or concerns, please contact our technical support at 877-200-3259 (US/CA) / 44-808-178-0934 (UK) or customer service at support@amadahome.com.
• DO NOT use this product for any purpose that is NOT explicitly specified in this manual. We are not liable for damage or injury caused by incorrect assembly or inappropriate use. Thank you for your understanding.
• WARNING: For use on flat, level surfaces only. Do not use on surfaces that are uneven or sloping.

Supplied Parts and Hardware

Tool Needed (NOT Included)

1. Step 1 Caster Installation

2. Gently loosen the lock [H4] and unfold the tripod base [A]. Then retighten the lock [H4]. WARNING: The tripod base contains potential pinch  points. DO NOT place hands on or near the moving joints.
   CAUTION: Distance between each leg must be greater than 20.5″ (520mm).

3. Insert casters [B] into the tripod legs and rotate clockwise to secure them.

4. Step 2 Connect the Upper Pole to the Foldable Tripod Base

5. Gently loosen the lock [H3]. Pull out the pole [A 1] to the desired height. Then cetlghten the lock [H3].

6. adjust Slightly the height. loosen the lock [H2]. Insert the upper pole [C] into the tripod base [A] and adjust the hight

7. Slide the lock [H2] to the joint between two poles. Then retighten the lock [H2] and bolt [T] to secure the height.

8. Step 3 Attach the Projector Tray [D] to the Upper Pole [C]

9. Step 4 Attach the Small Tray to the Upper Pole
   Attach the small tray [F] onto the upper pole [CJ. Rotate the lock [F1] until it secures against the pole. Do not over-tighten.

10. Step 5 Level and Height Adjustments
    NOTE : DO NOT adjust the stand with equipment on the tray.

11. Step 6 Install the Rubber Mat [G] and the Nylon Straps [H]
    Place the rubber mat [GJ on the tray [DJ. Slide the nylon straps [HJ over the tray.

• (US/CA)877-200-3259 (UK)44-808-178-0934
• support@amadahome.com
• 860-00880-00 Rev01

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>