star T3 Battery Holder User Manual
- June 6, 2024
- Star
Table of Contents
Battery Holder T3
User’s Manual
STAR MICRONICS CO., LTD,
Information
This manual contains operating instructions and important safety guidelines. The Battery Holder T3 is designed to charge only the Lithium-Ion battery pack compatible with the SM-T300 Series Portable Printers. The contents of this manual are subject to change without prior notice.
Suitable Environment for the Use of the Battery Holder is as Follows:
- Operation Temperature: 0^ to 40^ (No Condensation)
- Storage Temperature: -20^ to 60^
- Relative humidity : 5% to 95% (No Condensation)
- Altitude : 0 ~ 10,000 feet
- Cooling: Convectional (Non-Vented Case)
Warning / Safety Guidelines
- Keep the charger in a cool, dry place, away from direct sunlight, high temperature, and moisture.
- Do not insert foreign objects into the charger.
- Do not operate the charger if it appears damaged.
- Do not disassemble, incinerate, or short circuit batteries, the charger, or related components.
- Do not operate the charger when your hands or body are wet.
- Do not operate the charger near water.
- To reduce the risk of burning, unplug the charger before cleaning.
- This charger cannot be used for any other types of batteries.
- Use of any charger not approved for the SM-T300 Series can damage the batteries or the printer and will void the warranty.
- If you do not intend to use the battery pack for a long time, be sure to remove it from the printer, and do not leave it connected to a battery pack holder for external charging.
General Guidelines
- The recharging time depends on the voltage level and ambient temperature of the battery. Normally, it takes about four (4) to five (5) hours to completely recharge one battery pack.
- The battery is a consumable part that will gradually lose its lifespan over time, depending on the total number of usage hours.
Parts Breakdown
Using the Battery Holder T3
-
To install the battery pack, proceed as follows: – Insert the battery pack in the direction of the colored arrow.
-
To recharge the battery, install the battery pack in the Battery Holder T300. Insert the DC Plug into the charge connector and plug the AC Cord into a power outlet.
-
The T300 Series Battery Pack will begin the charge cycle.
NOTE: Only use the AC Cord approved for the SM-T300 Series. Usage of any other cord can damage the printer, battery, or battery pack and will void the warranty.
Copyright 2010-2021 Star Micronics Co., Ltd. im00113
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>