ALLSecurity Indoor Maglock User Manual

Electro maglock Installation User Guide (Concept & Accessories for Indoor Model)

Spec Model| FAS-W6OOLD| FAS- W6OOLDT| FAS-W6OODUAL-LDT| FAS- W1200LDT| FAS-W1200DUAL-LDT
---|---|---|---|---|---
Holding force| 600Ibs (272kg)| 600Ibs (272kg)| 600Ibs (272kg)x2| 1200Ibs (545kg)| 1200Ibs (545kg)x2
Voltage Input| 12DC/24VDC| 12VDC/24VDC| 12VDC/24VDC| 12VDC/24VDC| 12VDC/24VDC
Current| 480mA/240mA| 480mA/240mA| 480mA/240mA| 480mA/240mA| 480mA/240mA

General installation

DSU bracket for (Glass Frame & glass door)

LS bracket for out-swing door

U bracket for ( glass door )

ZL bracket for (In- swing door )

ZL bracket (full cover) for In- swing door

General Installation Steps

1.  Drill the armature plate holes in the door using the template provided.
2.  Attached is the armature plate to the door with hardware provided per the illustration.
3. Make sure the guide pins are in the two guide pinholes.
4. With the door closed mark the door frame at the edge of the armature in order to properly align the magnetic lock to the armature.
5.  Attached is the mounting plate to the door frame using the self–taping screw provided to align the mounting plate with the mark from the previous instruction .
6.  Insert the wires through the hole in the mounting plate and into the maglock unit attached is the magnetic lock unit to the mounting plate with the Allen head fixing screw.
7. Screw-in the anti-tamper nuts to prevent unauthorized access and to prevent the fixing from loosening over time.
8. Connect to power wires according to the instruction and test the system.
9.  It is recommended that you apply a light coat of silicone lubricant to the mating surface on a monthly basis to prevent rust.

Trouble Shooting

1. Door not locked→ incorrect wiring or no power supply

2. Reduced holding force→ Poor contact of electromagnet and armature.
   →Make sure the armature is loose enough that it can fully contact the electromagnet along the entire length.
   →The mating surface is dusty or damaged.
   →Improper input voltage or wire size.

3. Sensor not functioning
   →Improper attachment of electromagnet and armature
   → Modification of the PCB

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>