MAYNE Mail Post Assembly MIS001 Instruction Manual

: June 6, 2024
: MAYNE

Table of Contents

MIS001r6

Mail Post Assembly Instructions

MIS001r6

General Information:

Read instructions carefully before beginning assembly.
Identify each component from the material list.
Do not use excessive force when assembling components.
To clean this product, for best results use a soap solution and high-pressure water.
For missing or defective parts, please call toll-free 1-866-363-8834 or email customerservice@gomayne.com.

MAYNE Mail Post Assembly MIS001 - fig

Materials List:

(Westbrook mode! shown)

MAYNE Mail Post Assembly MIS001 - fig1

TOOLS REQUIRED

MAYNE Mail Post Assembly MIS001 - fig3

IMPORTANT NOTE

4×4 wood post, mailbox, and mailbox mounting hardware NOT included with any Mayne mail posts
Small mailbox recommended (up to albs), heavier mailboxes can be reinforced by securing 2 screws through the back of the mailbox directly into the post.
USPS guidelines recommend that the bottom of the mailbox should be installed 41 into 45in off the ground and the front of the mailbox should be set back 6 into 8in from the curb. Please refer to your local postmaster for any questions or concerns regarding the placement of your mail post.

MAYNE Mail Post Assembly MIS001 - fig4

Dig a 24″ deep hole in the desired location and insert a 4×4 wood post. Leave 48″ exposed above ground (53″ above ground required for the Woodhaven Sign Post). Fill in the hole with pre-mix concrete (not included) and level the wood post. Once the concrete has been given time to cure slide the decorative post over the wood 4×4 ensuring that the base sits flush with the ground.
Optional Ground Screw: Twist the screw into the ground and attach a 4×4 post (approx. 48″ length, not included) with the 5x lag bolts provided. Slide the decorative post over the 4×4.
For the Westbrook Plus, Newport Plus, and Charleston models, the arm is installed on the front of the post. Two lag bolts with washers are required in the top holes of the arm. Secure the bottom of the arm with one 3in screw using a plastic snap cap to cover the screw head (See diagram A). For the Newport Plus Double, the arms are installed on either side of the post using two 3in lag bolts with washers in the top holes of each arm and one 3in screw with a plastic snap cap in the bottom of each arm (See diagram B).
Westbrook Planter Arm Installation: Fasten the planter arm to the post as shown. Use a 3in lag bolt with a washer for the top and a 3in screw with a plastic snap cap in the bottom of the arm.
NOTE: Planter installation only applies to the Westbrook Plus model. We recommend drilling a 3/4 inch drainage hole in the bottom of the planter arm (See Diagram 3).
Woodhaven Address Arm Installation: To install the arm for the Woodhaven Sign Post configuration flip the arm upside down as shown and secure it to the post using a 3in screw with a plastic snap cap at the top and a 3in lag bolt at the bottom. Suitable for plaques measuring up to 14 inches in width (plaque not included).
For the Newport Plus, Westbrook Plus, and Charleston the mailbox arm requires the use of a mounting board or bracket to secure the mailbox. Using wood screws attach the board (or bracket) to the mailbox arm. Next, attach the mailbox to the board by securing screws through the holes on each side of the mailbox.
(mailbox, mailbox mounting board. and screws not included)
The Newport Plus Double arms also require the use of a mounting board (or bracket) to secure the mailbox. Use wood screws to attach the board to the mailbox arm at a 90-degree angle as shown above. Next, attach the mailboxes to the boards by securing screws through the holes on each side of the mailbox.