IKEA KULINARISK Wall Mounted Extractor Hood Stainless Steel Glass User Manual
- June 6, 2024
- Ikea
Table of Contents
Design and Quality
IKA OF Sweden
Please refer to the last page of this manual for the full list of IKEA appointed Authorized Service Centre and relative national phone number
Safety information
For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance.
The wire connection has to be done by a specialized technician.
- The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
- The minimum safety distance between the cooker top and the extractor hood is: for electrical hob 500mm and for gas hob 650mm.
- If the instructions for installation for the gas hob specify a greater distance, this must be respected.
- Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood.
- Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
- For Class I appliances, check that the domestic power supply guarantees adequate earthing.
- Connect the extractor to the exhaust flue through a pipe of a minimum diameter of 120 mm. The route of the flue must be as short as possible.
- Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.).
- If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. When the cooker hood is used in conjunction with appliances supplied with energy other than electricity, the negative pressure in the room must not exceed 0,04 bar to prevent fumes from being drawn back into the room by the cooker hood.
- The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent.
- Connect the plug to a socket complying with current regulations, located in an accessible place.
- With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.
WARNING: Before installing the Hood, remove the protective films.
• Use only screws and small parts in support of the hood.
WARNING: Failure to install the screws or fix the device in accordance
with these instructions may result in electrical hazards.
-
Connect the hood to the power net by using a bipolar switch having a contact gap of at least 3 mm.
-
Do not look directly at the light through optical devices (binoculars, magnifying glasses…).
-
Do not flambè under the range hood; risk of fire.
-
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision. -
Children should be supervised to ensure that they do not play with the appliance.
-
The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction
Accessible parts may become hot when used with cooking appliances.
- Clean and/or replace the Filters after the specified time period (Fire hazard).
- There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room)
- Kitchen hoods and other cooking fume extractors can affect the safe operation of appliances that burn gas or other fuels (including those in other rooms) due to the backflow of combustion gases. These gases can cause carbon monoxide poisoning. After installing a kitchen extractor hood or any other cooking fume extractor, make sure that the gas appliances are tested by a certified technician to guarantee that there is no backflow of combustion gases.
Use
- Switch off or unplug the appliance from the main supply before carrying out any maintenance work.
- The top of the hood must not be used as a shelf.
- The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
- Never use the hood for purposes other than for which it has been designed.
- Never leave high naked flames under the hood when it is in operation.
- Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.
- Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.
- the temperature of 70° or hand washes in hot water without using abrasive sponges (do not use detergents!)
- Dry in the oven at a MAX temperature of 70° for 2 hours or dry at room temperature, standing the Filter in a vertical position to facilitate drainage.
Care and cleaning
-
Grease filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a
dishwasher. -
Clean the hood using a damp cloth and a neutral liquid detergent.
Care and cleaning long life Charcoal filter (Green)
- The anti-odor Filter can be washed and regenerated every 3-4 months (or more frequently if the hood is subject to intensive use), up to a max. of 8 regeneration cycles (in case of particularly intensive use it is recommended that you do not exceed 5 cycles).
Regeneration procedure:
• Wash in the dishwasher at a MAX
Installation modes
The hood has been designed to be installed and used either as an “Exhaust
mode”, or as a “Recirculation mode”.
Exhaust mode (see a symbol in installation booklet)
Cooking steam is sucked and channeled outside the house through a discharge
duct (not supplied), fitted to the hood steam outlet. Ensure that the
discharge duct is correctly fitted to the air outlet, unit using an
appropriate connection system.
Recirculation mode (see the symbol
in installation booklet)
The air is filtered through one or more charcoal filters and then resent
into the room.
Important: Ensure appropriate air circulation around the hood.
Important: If the hood is supplied without charcoal filters and installed
on recirculation mode, these must be fitted before the hood can be used.
Filters are available in shops. The hood should be installed away from
particularly dirty areas, windows, doors, and heat sources. The accessories
for wall fixing are not included because walls made of different materials
require different types of fixing accessories. Use fixing systems suitable for
the walls of your home and the weight of the appliance. For more details,
contact a specialized dealer. Keep this booklet for future consultation.
Product description
Upper chimney- Lower chimney
- Hood body
- LED Lighting
- Grease filter
- Control panel
Control Panel
BUTTON|
FUNCTION
---|---
A = Speed| Turns the motor on/off at speed one.
B =
Speed| Turns the motor on at speed two.
Press and hold the button for approximately 2 seconds, with all the loads
turned off (Motor+Lights), to turn the Activated Charcoal Filter alarm on. LED
(A) flashes twice to confirm To turn the alarm off, press the button again and
hold for at least 2 seconds. The relevant LED flashes once (A).
C =
Speed| Turns the Motor on at speed three.
Press and hold the button for approximately 2 seconds, with all the loads
turned off (Motor+Lights), to reset the Filter saturation alarm. LED (A)
flashes three times.
D =
Speed| Turns the motor on at INTENSIVE speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated
with the motor turned off, it will switch to OFF at the end of the time. To
deactivate it, press button or press button A
E =
Light| Press briefly: Turns the lighting system on and off at maximum
intensity.
Press and hold to change the lighting intensity up or down.
General hints
- Switch ON the hood at minimum speed when you start cooking and kept it running for a few minutes after cooking is finished.
- Increase the speed only in case of a large amount of smoke and vapor and use boost speed(s) only in extreme situations.
- Replace the charcoal filter(s) when necessary to maintain a good odor reduction efficiency.
- Clean the grease filter(s) when necessary to maintain a good grease filter efficiency.
- Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise.
Care and cleaning
Switch off or unplug the appliance from the main supply before carrying out any maintenance work.
IMPORTANT Clean the hood using a damp cloth and a neutral liquid
detergent.
Long Life Charcoal Filter
The anti-odor filter can be washed and regenerated every 3-4 months (or more
frequently if the hood is subject to intensive use), up to a max. of 8
regeneration cycles (in case of particularly intensive use it is recommended
that you do not exceed 5 cycles). 
Grease Filters
Clean or replace the filters continuously according to the below time
intervals, to maintain good performance of the hood and to prevent a
potential fire hazard, caused by excessive grease build-up.
The grease filters must be cleaned every 2 months of operation, or more
frequently for particularly heavy usage, and can be washed in a
dishwasher.
Replacing the lamps
For Replacement please contact an Authorized Service Center.
What to do if…
If there is a fault, first try to find a solution to the problem yourself. If
you cannot find a solution to the problem yourself, contact an authorized
service center.
If you operated the appliance wrongly or the installation was not carried out
according to the Assembly instructions, the visit from the Authorized Service
Centre technician may not take place free of charge, even during the warranty
period.
PROBLEM
| POSSIBLE CAUSE|
SOLUTION
---|---|---
The appliance is not stable.| The appliance is not correctly installed.|
Follow the Installation instruction enclosed to the appliance.
Appliance is not in a horizontal position.| The appliance is not correctly
installed.| Follow the Installation instruction enclosed to the appliance.
Performance in terms of oil capture is not satisfying.| Oil and grease on
metal filters or charcoal filters.| Follow the cleaning frequency of filters
as described in the user manual.
The appliance does not work.
| The appliance is not correctly connected.| Verify that the main cable is
connected to the motor group or the plug is connected to the socket.
The light does not work.| The LED is broken.| For replacement, contact the
Authorized Service Centre.
The noise of the hood is higher than customer expectations.| The air outlet
diameter in the wall is too small, causing a pressure drop and an increase in
motor speed.| Follow the Installation instruction enclosed to the appliance.
The product is installed in recirculation mode.
| Product in recirculation mode(and using a charcoal filter) will generate a
higher noise than a product in extraction mode.
More than one bend in the ventilation duct.| If the exhaust system in the
building has multiple bends in or a long distance, this can increase the noise
of the product.
Button A light flashing once per
second.
| Grease filter alarm.| Please clean the grease filter and reset the alarm.
Refer to care and cleaning guide for maintenance and control panel guide to
reset the filter alarm.
Button A lights flashing twice per second.| Charcoal filter alarm.| Please
clean the charcoal filter and reset the alarm. Refer to care and cleaning
guide for maintenance and control panel guide to reset the filter alarm.
Before contacting the Authorized Service Centre:
Switch the appliance on again to see if the problem has disappeared. If not,
switch it off again and repeat the operation after an hour.
If your appliance still does not work properly after carrying out the checks
listed in the troubleshooting guide and switching the appliance on again,
contact the Authorized Service Centre, clearly explaining the problem and
specifying:
- the type of fault;
- the model;
- the type and a serial number of the appliance (given on the rating plate).
Technical Data
| Unit| Value
---|---|---
Product Type| | Wall-mounted hood
Dimensions| Width| mm| 898
Depth| mm| 460
Height min/max| mm| 730/1010
Airflow max – Exhaust| m3/h| 380
Noise max – Exhaust| dBA| 59
Airflow max – Recirculating| m3/h| 340
Noise max – Recirculating| dBA| 74
Total Power| W| 276
Lamps info
| Type| | LED BAR
Number & Power| | 1 x 6W
Socket| | N/A
Installation minimum height – gas hob| mm| 650
Installation minimum height – elec hob| mm| 500
Net Weight| Kg| 15
- Maximum speed (boost excluded).
This appliance has been designed, manufactured, and marketed in compliance
with the E.E.C. Directives.
The technical information is situated in the rating plate on the internal side
of the
Energy
efficiency
Product Information according to EU n°66/2014| Unit|
Value
---|---|---
Model identifier| | KULINARISK 403.831.48
Annual Energy Consumption| kWh/a| 34,8
Time increase factor| | 0,6
Fluid Dynamic Efficiency| | 37,6
Energy Efficiency Index| | 36,6
Measured air flow rate at best efficiency point| m3/h| 406,0
Measured air pressure at best efficiency point| Pa| 463
Maximum airflow| m3/h| 700
Measured electric power input at best efficiency point| W| 139
Nominal power of the lighting system| W| 6,0
Average illumination of the lighting system on the cooking surface| ****
lux
| ****
350
Measured power consumption in standby mode| W| N/A
Measured power consumption off mode| W| 0,49
The sound power level at maximum speed (boost excluded)| dBA| 59
Normative references:
EN/IEC 61591
EN/IEC 60704-1
EN/IEC 60704-2-13
EN/IEC 60704-3
EN 50564
Energy saving
The appliance contains features that help you save energy during everyday
cooking.
Environment concerns
Maintenance
- The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed
of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about the recycling of this product, please contact your local city office, your household waste disposal service, or the shop where you purchased the product.
Packaging materials
The materials with the symbol are recyclable. Dispose of the packaging in suitable collection containers to recycle it.
IKEA GUARANTEE
Do you need extra help?
For any additional questions not related to After Sales of your appliances,
like clarifications on the installation of the IKEA appliance in the dedicated
IKEA kitchen furniture or for clarification on functions of the IKEA
appliances, please contact our nearest IKEA Customer Support Centre, the
number is available on www.IKEA.com. We recommend you
read the appliance documentation carefully before contacting us.
Read about our guarantee terms on www.ikea.com.
For requests under this guarantee, do not hesitate to contact the IKEA-
appointed Authorized Service Centre.
See the relative national phone numbers on the next page.
For quicker service, always refer to the IKEA article number (8-digit code)
and the 12-digit service number found on the rating plate of your appliance.
SAVE THE SALES RECEIPT
© Inter IKEA Systems B.V. 2017 23199 AA-2027177-9
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>