STEVAL-LLL011V1 12 Channel LED driver Evaluation Board User Guide

June 6, 2024
ST

STEVAL-LLL011V1 12 Channel LED driver Evaluation Board User Guide

Hardware overview

Hardware overview
Hardware overview

STEVAL-LLL011V1 Hardware Description
  • The STEVAL-LLL011V1 contains 4 LED1202 ICs and 16 RGB LEDs. It can work in standalone mode or together with the STSW-LED1202GUI PC SW by the onboard USB connector. Two user buttons allow to interact with the board by implementing user scripts. Additionally, an external LiION battery can be connected to the board (see the slide 4).
  • The PWR button is used to switch on/off:
    • A short press to switch the board on
    • A long press to switch the board off
  • User scripts can be developed and uploaded on the board, using the SW GUI. Then, the scripts are launched by pressing the DEMO button. Each time the DEMO button is pressed, the next script is executed.

Configuration Setup

Configuration Setup
Configuration Setup
ST-LINK Connection for FW Programming

ST-LINK Connection

JTAG CONNECTOR

NAME| NUMBER
VCC| 1,2
SWDIO| 7
SWCLK| 9
RST| 15
GND| 2..20 Even Pins

Battery Option

  • The STEVAL can be supplied by using an external Li-ION battery. Charge current is configured in order to charge a 320mAh battery in about 80 minutes: D2 LED lights when charging.
    Battery Option

STSW-LED1202GUI

  • The STEVAL-LLL011V1 comes with a SW PC that gives the user a total access to the 4 LED drivers functionalities. For details about the use of the SW GUI, please refers to the SW user manual (UM2747).
    Table graph

STEVAL – GUI communication

GUI communication

Once the STEVAL is supplied:

  • Connect the USB cable.

  • Press the Power Button (SW4) : the PWR LED lights up (D1).

  • If the USB cable has been connected for the first time, please wait that OS
    registers and enumerates the new HW, as Virtual COM port.

  • Launch the SW GUI.

STEVAL-LLL011V1 user scripts

The STEVAL-LLL011V1 can be programmed in order to launch small user scripts. These scripts are developed inside the SW GUI and then uploaded on the STEVAL.

Instructions on how to develop and upload the scripts are reported on the SW user manual (UM2747)
SW user manual

Once uploaded, the scripts are launched by pressing the SW2 button.

SW user manual

Revision History

Rev Date Description
1.0 12/07/2019 First Release

1.1
1.2| 22/10/2019| First Review
02/12/2021| Added details on board startup

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals