NEXSENS UW6-BB X2 Battery Backup User Manual
- June 6, 2024
- NEXSENS
Table of Contents
NEXSENS UW6-BB X2 Battery Backup
What’s Included
Battery enclosure mounting hardware
• (2) Mounting braces
• (2) 5/16-18 x 2” U-bolts
• (8) 5/16” flat washers (4 installed on U-bolts)
• (4) 5/16” split-lock washers (installed on U-bolts)
• (4) 5/16-18” Hex nuts
• (4) 1/4-20 x 7/16” Flat head screws
Battery Box Mounting
-
Set the battery enclosure on its face and align one of the included mounting braces with the top threaded inserts.
a. Secure the brace using the included Phillips-head screws, a lock washer, and a flat washer.
b. Thoroughly tighten the screws using a Phillips screwdriver.
Figure 1: Install brace for battery enclosure. -
Attach the other mounting brace to the 2” NPT deployment pipe or MAST accessory using one of the included U-bolts.
a. Place the included flat washer, lock washer, and nut on each U-bolt thread.
b. Evenly tighten the brace using a 1/2” socket.
Figure 2: Install second brace on pipe mount.
-
Align the bottom threaded inserts of the battery box with the brace mounted on the pipe.
a. Secure the lower brace using the remaining phillips-head screws, lock washer, and flat washer.
b. Run the remaining U-bolt around the pipe and through the top brace.
• Secure it with the remaining flat washer, lock washer, and nuts. Evenly tighten the brace using a 1/2” socket.
Figure 3: Battery enclosure installed on pipe mount.
Data Logger Connection
Once the box is mounted:
- a. Connect the AC adapter to the AC IN port on the battery enclosure.
- The included AC adapter is keyed to prevent misconnections.
- b. Connect the included orange UW6-2P cable to the PWR OUT port on the battery enclosure.
- The free end of the UW6-2P cable connects to the 6-pin port of the X2 data logger to supply system power.
Figure 4: AC adapter and data logger connection to battery enclosure
ports.
IMPORTANT – Ensure to provide a waterproof enclo- sure for the AC adapter’s barrel connection if using in a high humidity environment.