NEXSENS CB-Series CB-MCL Data Buoy Wet-Mate Lid Instruction Manual
- June 5, 2024
- NEXSENS
Table of Contents
- NEXSENS CB-Series CB-MCL Data Buoy Wet-Mate Lid
- Overview
- What’s Included
- **MCBH Bulkhead Installation (Sold separately)
- Solar Panel Connection
- CB-MCL Solar Connector Wiring Information
- MCBH Connection with NexSens MCIL Connectors
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
NEXSENS CB-Series CB-MCL Data Buoy Wet-Mate Lid
Overview
The NexSens CB-MCL Wet-Mate Lid is compatible with CB-150 and larger data buoys. It is designed for use with MCBH bulkhead connectors (sold separately).
What’s Included
Wet-Mate Lid
- (1) CB-MCL Solar Connector
- (1) Vent Port
- (1) Bushing Connector
- (1) Solar/COM Port Adapter
**MCBH Bulkhead Installation (Sold separately)
**
Remove the nut and flat washer from an MCBH bulkhead connector.
- Route the wires through an open hole on the wet-mate lid.
- Reinstall the nut and flat washer and tighten to the plate. Ensure the O-ring underneath the connector stays in place.
Apply an adhesive, such as a marine goop, to the nut underneath the plate.
- Ensure the adhesive for all connectors is fully cured before installing the plate on the buoy
Repeat this process for all cables that will be inserted through the pass- through plate and into the buoy well.
- For the remaining unused ports, ensure to install a water-tight blank connector before deployment.
Solar Panel Connection
Remove the 6-pin blank plug from the SOLAR port. Plug the CB-MCL solar connector into the SOLAR port. To apply power from the solar tower, connect the solar tower plug to the 6-pin receptacle end of the CB-MCL solar connector.
CB-MCL Solar Connector Wiring Information
CB-MCL Solar Connector Receptacle Pin | Wire Color |
---|---|
1 | Orangeb |
2 | Yellow |
3 | Blacka |
(Both black wires)
4| Red
(Only on Molex connector)
The free red (+++) and black (—) wires are for power and ground connection to an external device. Note: The information below refers to a connection with a NexSens solar tower. The solar tower plug is connected to both black wires (ground) and a single yellow wire (power). The orange Molex wire and the red flying lead wire are shorted together.
MCBH Connection with NexSens MCIL Connectors
When connecting a sensor with a factory-installed NexSens MCIL connector, follow the wiring diagram below for information on the sensor’s power, ground, and communication lines.
Wire Number | NexSens Signal |
---|---|
1 | RS-232 Tx |
2 | Ground |
3 | RS-232 Rx |
4 | — |
5 | Power |
6 | SDI-12 |
7 | RS-485 B |
8 | RS-485 A |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>