PHILIPS DDBC320-DALI 2 Driver Controller Installation Guide
- June 6, 2024
- Philips
Table of Contents
DDBC320-DALI
DALI-2 Driver Controller
Installation Instructions
Devices must be installed in an approved enclosure by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Output Ratings/Channel (CH)
Control Channel Ratings
Output Ratings/Group
Caution – DALI wires are NOT SELV and should never be considered touch-safe.
Basic insulation or higher is required between DALI wires and mains cabling.
Caution – Any modifications not approved by the manufacturer of this device
could void the user’s authority to operate this device.
FCC and RSS-210 of IC (Industry Canada) Rules – This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules and pursuant to RSS210 of the IC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help. Any modifications not approved by the
manufacturer of this device could void the user’s authority to operate this
device.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la
norme NMB003 du Canada: CAN
ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply
with HD 60364-4-41. The temperature limits and current-carrying capacities for
the communication wires specified in HD 384.5.523 shall not be exceeded.
© 2021 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
AZZ 531 0821 R02
www.lighting.philips.com/dynalite
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>