Hatch 529561 Sleep Headband For Restore User Guide
- June 6, 2024
- Hatch
Table of Contents
Sleep Headband
FOR RESTORE
User Guide
Hatch Sleep Headband is compatible with your Hatch Restore smart sleep
assistant.
To connect headband to Restore:
-
Use included
Micro-USB cord to charge headband, then power on -
Visit settings in the Hatch Sleep app
-
Select “Pair Headphones”
Once on, headband automatically connects to the last connected device available.
Headband Controls
| Button | Action | |
|---|---|---|
| Power On/Off | Press + hold for 3 seconds | |
| Volume Up/Down | – + | Short press |
Note: Only 1 Bluetooth connection per Restore assistant is permitted at one time. To connect the Restore device to different headphones, use phone Bluetooth settings to unpair the / forget the device.
Wash Instructions
- Remove control panel by pushing out of pocket than through the opening at the back headband.
- Similarly, remove speaker discs located on each side.
- Hand or machine wash in cold water.
Lay flat to dry.
Specifications
- Charging: 22.5 hours for full charge
- Usage: 11-12 hours on one charge
- Bluetooth® version: V 5.0+ EDR
- Rechargeable Lithium Battery: 230 mAh
- Micro-USB Charge: 5V/0.5A
Need help?
Hatch support is a dream.
Contact us at support@hatch.co
Follow @hatchforsleep and see what dreams are made of.
FCC Caution: Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment. This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
IMPORTANT NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement: This equipment complies with FCC
radiation exposure limits set forth for an uncontrolled environment. ISEDC
Warning This device complies with Innovation, Science, and Economic
Development Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1)this device may not cause interference, and
(2)this device must accept any interference, including interference that may
cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>