Philips EasyAir SNS210 User Guide

www.phlips.com
Quick Installation Guide
Philips EasyAir SNS210 with Philips field app MC

“ This guide shows a few key concepts to work with EasyAir SNS210 MC using Philips field app MC.”

1. Prepare smart luminaries
   With Xi SR driver and EasyAir SNS210 MC

2. Install Components
   The physical installation with wireless components

3. Install App
   Download the Philips field app MC on your phone and register

4. Set
   Use the app for grouping, controlling lights, and on-site configuration work.

5. Report
   Check the energy report

Philips Xitanium SR driver

• Standardized open SR interface (now D4i)
• Low voltage power supply for sensors
• 4% accurate power metering

Philips EasyAir SNS210

• Motion and daylight sensing
• Simple two-wire connection to Xitanium SR driver
• Wireless communication with other SNS210 devices
• Suited for offices, hospitals, and schools

App

• Easy setup and configuration via Philips field app MC

Wireless switch

• Work with Zigbee Green Power switches
• For manual control: switching and dimming
• Supported switches: Philips, Jaeger Direkt, Vimar, XTouch

Build wireless and smart luminaires

Get started with the app

The Philips field app MC is the tool to set up and configure the system after installation.

•  Works with Bluetooth
• Available for iPhones and Android smartphones

Create a project

1. Register via email.
2.  Waiting for a 6-digit verification code via email.
3. Log in to the Philips field app MC. Use the email address and verification code you just received from the email.
4. Tap a project name and the location (optional), then tap Create a project to continue.
5. Start adding groups to commission the project.

Commissioning

1. Tap the ‘+’ button to create a group.
2. Tap the ‘+’ button to add lights.
3. Wait a few seconds for the app to discover devices.

• There are two ways of adding devices:
• Point and trigger: Use Torchlight to add devices
• List-based: Add devices based on BLE signal strength

Configuration

Notes
Light behavior can be programmed via Philips field app MC e.g. light levels, group light behavior, hold/prolong times, etc.
Steps

• After adding the lights, tap the button
• Tap ‘Edit configuration’
• Using the app to check or change the parameters.
• Tap ‘Save and apply’

Device Data Readout

Check the energy report
Read energy usage of the group via Philips field app MC
Steps

• Tap ‘Group info’
• Tap ‘Create new report’
• View history and download the report to view older readings

Add a switch

Add a switch to control the lights
Steps

• Tap the ‘+’ button to add a switch
• Choose the switch you have
• Follow the instructions to set up the switch
• Set scenes for more control

www.lighting.philips.co.uk/oem-emea/products/connected- lighting

© 2021 Signify Holding. All rights reserved. The information provided herein is subject to change, without notice. Signify does not give any representation or warranty as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance thereon. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract unless otherwise agreed by Signify.
Philips and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
01/2021
Data subject to change

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>