cellularline BTARIESTWSW Aries Wireless Stereo Bluetooth Earbuds with Charging Case User Guide

Aries
WIRELESS STEREO BLUETOOTH® EARBUDS
WITH CHARGING CASE
ISTRBTARIESTWSW

Description:

1. MF (multifunction) button
2. LED
3. Charging Case charging LED
4. Charging Case residual charge LED
5. MicroUSB charging port
6. MicroUSB charging cable

PRELIMINARY OPERATIONS

Charging Case Charge: Charging Case has an internal battery that allows the earbuds to be recharged without being plugged into a mains charger. The Charging Case must therefore be charged before recharging the batteries of the devices.
Connect the charging cable (6) to any USB port and connect the other end to the MicroUSB charging port (5); the red LED (3) will flash and turn off when recharging is complete.
Once you have finished recharging, disconnect the Charging Case from the power supply.
Charging Case battery indicator: refer to the flashing LED (3) while recharging the Charging Case:

• When the LED flashes red once every two seconds, from 1% to 25% charge
• When the LED flashes red twice every two seconds, from 25% to 50% charge
• When the LED flashes red three times every two seconds, from 50% to 75% charge
• When the LED flashes red four times every two seconds, from 75% to 100% charge.

The LED (3) will show a steady red light when recharging is completed (100%).
Recharging the earbuds: insert the devices in their respective docks and close the Charging Case flap, charging will start automatically. The red LED (2) turns on when charging is in progress. The LED (2) turns off when charging is complete.
Phone connection: before connecting ARIES to the phone, it is necessary to establish a connection between the two earbuds. Remove the individual earbuds from the charging dock. The LEDs (2) will begin to flash white. The earbuds will connect within a few seconds.
Once the connection has been established, the LED (2) on one of the earbuds will flash white/red in an alternating fashion, indicating that the pairing mode is active.
Turn on Bluetooth® on your phone to run a search for devices and select ARIES when it is detected.

USING THE DEVICE IN STEREO MODE

Turning the unit on: remove the earbuds from the Charging Case or hold down the MF buttons of both devices for about 2 seconds.
Turning the unit off: put the earbuds inside the Charging Case or hold down the MF buttons of both devices for about 2 seconds.
To answer a call: you can answer calls from both earbuds by pressing the MF button (1). If both earbuds are inside the Charging Case when there is an incoming call, take out the right or left earbud, wait for the connection and then answer by pressing the MF button.
To answer a call: you can answer calls from both earbuds by pressing the MF button (1).
If both earbuds are inside the Charging Case when there is an incoming call, take out the right or left earbud, wait for the connection and then answer by pressing
the MF button.
To end a call: you can end calls from both earbuds by pressing the MF button (1).
Play/Pause: press the MF button (1) of one of the two earbuds once.
Voice assistant: press the MF button (1) on the right earbud twice.
FF: press the MF button (1) of the right earbud for about 2 seconds to fast forward to the next track.
Rew: press the MF button (1) of the left earbud for about 2 seconds to rewind to the previous track.
Volume control: use the phone’s volume buttons to adjust the volume of the earbuds.
Device flat battery indicator: if the LED flashes red, the battery is flat.
Charging Case flat battery indicator: When the Charging Case charge is below 25% the white LED (4) will flash quickly.
RESET: if there are any anomalies in the operation of the device, it is possible to carry out a reset to restore the initial operation.

• Delete previous pairings from the Bluetooth® menu of the device and disable Bluetooth®
• Switch off the earbuds by pressing down their buttons until the red LED lights up.
• Take one earbud and press the button for about 10 seconds. The LEDs will flash first white and orange, then you will see the LED flash white three times and then red once.
• Take the other earbud and follow the same procedure. Keep the button pressed for about 10 sec.
• Place the earbuds inside the case and close the cover.
• Take out the earbuds (the LEDs of both will flash orange) and press the buttons twice at the same time. The LEDs will quickly flash orange/white, then only one of
  the two will continue to flash.

Pair again. Turn on Bluetooth® on the phone and select ARIES after it has been detected.

HEADSET TECHNICAL SPECIFICATIONS:

Cellularline S.p.A. declares that this Bluetooth headset with a charging case complies with Directive 2014/53/EU.
The full text of the EU Declaration of conformity is available at the following Internet address: www.cellularline.com/_/declaration-of- conformity.
Cellularline S.p.A. also declares that this Bluetooth headset with charging case complies with Directive 2011/65/EU updated from 2015/863/EU.

INFORMATION ON THE STATUTORY WARRANTY

Our products are covered by a statutory warranty against conformity defects in accordance with applicable national consumer protection laws.
For more information, please see the following page www.cellularline.com//warrant

INSTRUCTIONS FOR THE DISPOSAL OF DEVICES FOR DOMESTIC USE (Applicable in countries in the European Union and those with separate waste collection systems)
This mark on the product or documentation indicates that this product must not be disposed of with other household waste at the end of its life. To avoid any damage to health or the environment due to improper disposal of waste, the user must separate this product from other types of waste and recycle it in a responsible manner to promote the sustainable re-use of the material resources.
Domestic users should contact the dealer where they purchased the product or the local government office for all information regarding separate waste collection and recycling for this type of product. Corporate users should contact the supplier and verify the terms and conditions in the purchase contract.
This product must not be disposed of along with other commercial waste.
This product has a battery that cannot be replaced by the user. Do not attempt to open the device to remove the battery as this could cause malfunctions and seriously damage the product. When disposing of the product, please contact the local waste disposal authority to remove the battery. The battery inside the device was designed to be able to be used during the entire life cycle of the product.
For more information, visit the website http://www.cellularline.com

Using the device may, in some cases, interfere with the correct functioning of medical devices (e.g. pacemakers).
Prolonged exposure to high volume and prolonged use may cause permanent damage to hearing.
Do not use the device in places where being unable to hear external noises could prove dangerous (e.g. railway crossings, train platforms)
If used when driving, comply with the regulations in force in the relevant country.
Children should be supervised when using the device and all accessories and packaging should be kept out of their reach. Do not expose the device for prolonged periods to dampness, dust, soot, steam, direct sunlight, and excessively high or low temperatures, which could result in it malfunctioning Use only suitable chargers for charging Regularly charge the product (at least once every 3 months).

Via Lambrakis 1/A
42122 Reggio Emilia, Italy
www.cellularline.com
R1120

Documents / Resources

| cellularline BTARIESTWSW Aries Wireless Stereo Bluetooth Earbuds with Charging Case [pdf] User Guide
BTARIESTWSW, Aries Wireless Stereo Bluetooth Earbuds with Charging Case
---|---
| cellularline BTARIESTWSW Aries Wireless Stereo Bluetooth Earbuds with Charging Case [pdf] Instruction Manual
BTARIESTWSW, Aries Wireless Stereo Bluetooth Earbuds with Charging Case

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>