STORYTELLER 100000652 Myvolta Bluetooth Hardware Instructions
- June 6, 2024
- STORYTELLER
Table of Contents
MYVOLTA
BLUETOOTH
HARDWARE
INSTALLATION
INSTRUCTIONS
REV 02.01.2021
LET’S GO!!
Thank you for your purchase. This is an easy install but please read these
Installation Instructions before getting rolling with this project.
Take your time and be mindful with the tools as personal harm and/or damage is
possible if you’re not careful.
Only install this product with the supplied hardware as substituting or
modifying hardware could damage your awesome rig.
Thank you for supporting the Overlanding community. We are jealous that we
can’t join you out on the open road and beyond but sincerely hope this product
will enrich your travels.
- Your pals at Storyteller Overland
PARTS INCLUDED:
- (1) my volta Bluetooth module
- (1) my volta Y cable
TOOLS NEEDED:
- T 20 Torx screwdriver
- Your hands
STEP 1:
Remove the product from the package and insert the single end into the myVolta
Unit.
STEP 2 :
With your Volta system powered OFF remove the (4) 1/2″ Torx T 20 Hex
screws that hold the M-Power Control Center panel in place indicated by the
STEP 3:
Let the M-Power Control Center panel hang gently. Disconnect the wire going
into the center of the State of Charge gauge.
STEP 4:
Remove the adhesive and stick the myVolta box on the inside of the panel
(steps 1-4).
STEP 5 :
Connect the female end of the Y cable to the back of the SOC gauge.
Connect the male end of the Y cable to the existing wiring harness.
STEP 6:
Replace the (4) T 20 Torx screws in the M-Power Control Center faceplate (do
NOT overtighten)and you’re all finished.
STEP 7:
Download the myVolta app and connect. Refer to: voltapowersystems.com for more
information.
WARRANTY
VOLTA MANUFACTURES AND OFFERS A WARRANTY ON THIS SYSTEM. IF, BY CHANCE THIS
PRODUCT FAILS, PLEASE CONTACT VOLTA DIRECTLY.
VOLTAPOWERSYSTEMS.COM/CONTACT
LIVE FREE.
EXPLORE ENDLESSLY.
TELL BETTER STORIES.
STORYTELLEROVERLAND.COM
COPYRIGHT © 2021
STORYTELLEROVERLAND, LLC.
ALL RIGHTS RESERVED.
