SILVERSTONE iCEGEM360 High Performance All in One Liquid Cooler User Manual
- June 6, 2024
- SilverStone
Table of Contents
User’s Manual
Accessories
Please confirm the connector, the definition, and direction of your pin header
when connecting cables
Ensure ARGB controller/motherboard has same +5V pin definition as
iG240P/iG280/iG360 PSU
ARGB controller
Instructions for ARGB controller
-
There are three buttons on this controller, “+ / – / M”
-
M button: Press M button to switch to lighting effect mode, speed of lighting mode, brightness mode,
and demo mode
Press “+” or “–“ to adjust desired levels -
Press M button for 3 seconds to turn off, press M button again to turn on and resume to the last
lighting effect mode before turning off -
When powered on for the first time, the default lighting effect is “Rainbow”
-
After turning off or sudden power loss, the controller will resume to the last set lighting effect mode and
level after power on -
Press “–“ button for 3 seconds under any modes will reset to default effect (Rainbow)
-
Lighting effect mode
- Rainbow (default)
- Breathing
- Flashing
- Layering (8 colors: white, indigo, violet, yellow, blue, red, green, orange)
- Flowing
- 256 colors auto-switching (8 colors: white, indigo, violet, yellow, blue,
red, green, orange)
Press “+” for 3 seconds to lock the chosen color; press “–“ for 3 seconds to unlock color. - Radar
- Color layering, red
- Color layering, green
- Color layering, blue
-
Press M button to switch mode
Press “+” or “–“ when the controller’s red indicator lights up to adjust the speed of lighting (fast/slow) -
Press M button to switch mode
Press “+” or “–“ when the controller’s blue indicator lights up to adjust brightness -
Press M button to switch mode
Under demo mode, the controller’s yellow indicator lights up and will display and recycle all 10 lighting effects continuously