Mattel R0000-MA70-G3 RC Battery Information Flyer 21A Instruction Manual

Mattel R0000-MA70-G3 RC Battery Information Flyer 21A Instruction Manual

CONSUMER INFORMATION Keep these instructions for future reference as they contain important information. IMPORTANT: Please read all instructions before operating your vehicle.

⚠ CAUTION:
Surfaces may become hot and cause burns if electronics get wet. To prevent entanglement, keep all hair away from moving parts.
Adult supervision is recommended when the vehicle is being operated.
Protect the environment by not disposing of this product or any batteries with household waste. This symbol indicates that this product shall not be treated as household waste. Check your local authority for recycling advice and facilities.

ONLY APPLICABLE FOR TOYS WITH USB CABLE INCLUDED.
The toy is only to be connected to Class II equipment bearing the symbol .
Regularly examine the power supply used with this toy for damage to the supply cord, plug, enclosure or other parts, and in the event of damage.

TIPS & HINTS ­ FOR ALL DRIVING ENVIRONMENTS

1. When your vehicle starts to lose power, it may lose functionality or performance. It’s time for a recharge/fresh batteries. For best performance, always start with a fully-charge/fresh battery. Your vehicle’s running time may change depending on driving style and driving environment.
2. Radio interference can make your vehicle run poorly. Interference can be caused by other RC vehicles running on the same frequency, electrical wires, large buildings, CB radios, or other wireless gear. Try to stay away from these!
3. Point your remote controller up, and not down toward your vehicle. If your vehicle gets too far away, it won’t work properly.
4. Don’t store your vehicle near heat or in direct sunlight. Always turn switches OFF and remove all batteries from remote controller before storage.
5. Don’t drive your vehicle in sand or through water or snow. Do not immerse in water. If your vehicle does get wet, wipe it with a towel and allow to dry completely overnight. If your remote controller is accidentally dropped in water, remove battery(ies) and allow your remote controller to air dry. Replace with fresh battery(ies) before operation.
6. When exposed to an electrostatic source, the remote controller and/or the vehicle may malfunction. To resume normal operation of the remote controller, remove the batteries and reinstall them after 5 seconds. To resume normal operation of the vehicle, turn the power OFF for 5 seconds, then turn it ON again.
7. Play safely! Do not drive the vehicle in the street!

SAFETY TIPS
Play safely! Do not drive the vehicle in the street!

• DO NOT pick up the vehicle while in motion.
• Keep fingers, hair, and loose clothing away from the wheels while the vehicle is switched ON.
• Adult supervision is recommended when this vehicle is being operated.
• To avoid accidental operation, remove all batteries from the remote controller when not in use and switch the vehicle OFF before storage.

FOR PRODUCT SOLD IN USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

FOR PRODUCT SOLD IN CANADA (B)/NMB-3(B This equipment complies with FCC & Canada radiation exposure limits set forth for uncontrolled environments. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

GENERAL BATTERY SAFETY INFORMATION
Non-rechargeable batteries are not to be recharged. · Do not dispose of the batteries in a fire. The batteries inside may explode or leak. · Dispose of battery(ies) safely.

RECHARGEABLE BATTERY SAFETY INFORMATION
Rechargeable batteries are only to be charged under adult supervision.

• Do not recharge battery if it is hot. Allow it to cool before recharging.
• Do not recharge a battery pack that shows leakage or corrosion.
• Do not disassemble the battery pack. The battery pack is a sealed rechargeable Li-ion battery pack.
• If the battery pack and/or charging port are wet, thoroughly dry before charging.
• If the rechargeable batteries are removable, they are to be removed from the product before being charged.

BATTERY SAFETY INFORMATION – FOR PRODUCTS WITH NON-RECHARGEABLE DRY CELL BATTERIES
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (+ and ­).
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.

©2023 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>