BTSEEKTWSK Bluetooth Earphone with Charging Case User Guide
- June 6, 2024
- Seek
Table of Contents
BTSEEKTWSK Bluetooth Earphone with Charging Case
User Guide
SEEK
Description:
- Multifunction Button
- LED
- Charging Case charge state display
- USB-C charging port
- USB to USB-C charging cable
PRELIMINARY OPERATIONS
Charge the Charging Case and earbuds before setting up for the first time.
PHONE CONNECTION: before connecting SEEK to the phone, it is necessary to
establish a connection between the two earbuds. Remove the earbuds from the
Charging Case. Both LEDs will light up blue, the earbuds will connect with
each other within a few seconds and the LED on one or both earbuds will flash
alternately red/blue.
Enable Bluetooth on your phone to search for devices, and select SEEK when it
is detected.
USE
Switch on: remove the earbuds from the Charging Case or hold down the
multifunction button for about five seconds if the earbuds are not in the
Charging Case.
Switch off: put the earbuds back in the Charging Case or hold down the
multifunction button for about five seconds.
Answer a call: you can answer calls from either earbud by pressing the
multifunction button once.
If both earbuds are in the Charging Case when a call arrives, remove either
the right or left earbud, wait for it to connect, and then press the
multifunction button to answer.
End a call: you can end calls from either earbud by pressing the
multifunction button once.
Voice assistant: press the touch control (1) on the right or left earbud
3 times.
Play/Pause: press the multifunction button on either of the two earbuds
once.
FF: press the multifunction button on the right earbud for two seconds to
fast forward to the next track.
Rew: press the multifunction button on the left earbud for two seconds to
rewind to the previous track.
Speaker volume adjustment: press MFB touches control (1) of the right
earbud twice to increase the volume. To decrease it, press MFB touches control
(1) of the left earbud twice.
Flat earbud battery indicator: an acoustic signal indicates that the
earbud battery is low.
Charging Case charge state indicator: the display shows the charge state
of the Charging Case.
Charging the Charging Case: Use the supplied cable to charge the Charging
Case. The display will show the percentage charge.
Once you have finished charging, disconnect the Charging Case from the power
supply.
Charging the Earbuds: the Charging Case has an internal battery for
charging the earbuds without a direct power supply, so keep the Charging Case
battery charged.
Insert the earbuds in their respective docks and close the Charging Case flap.
Charging will start automatically and the LEDs will light up continuously red.
The LEDs will turn off when charging has finished.
Reset: if the device malfunctions, it can be reset to restore the initial
operation:
- delete the earbud pairing from the phone, disable Bluetooth® and reboot the phone.
- remove the earbuds from the Charging Case and press both multifunction buttons to switch them off
- Once they are off, hold the multifunction button down and pay attention to the LED flashing sequence (on both earbuds):
- red flash
- blue double flash
- red and blue flash
- red and blue flash (one earbud only)
- red flash
- off
Release the button.
- insert the devices in the Charging Case and close the flap.
- now repeat the initial pairing procedure.
EARBUDS TECHNICAL SPECIFICATIONS:
Bluetooth®: v5.0
Supported profiles: Headset – Handsfree – A2DP – AVRCP
Range: 10m
Bluetooth® Frequency Range: 2402-2480MHz
Battery voltage: 3.7V
Battery capacity: 30mAh X 2
Charging case battery capacity: 250mAh
MicroUSB port Voltage (V): 5V
MicroUSB port current (A): 300mAh
ERP Power: 8dB
Stand by Time: 10 hours
Talk Time: 3 hours
Play Time: 3 hours
Earbud charging: approximately 1.5 hours
Charging the Charging Case: approximately 2h
Weight: 32g
Cellularline S.p.A. declares that this Bluetooth headset with a charging case
complies with Directive 2014/53/EU.
The full text of the EU Declaration of conformity is available at the
following Internet address: www.cellularline.com/_/declaration-of-
conformity.
Cellularline S.p.A. also declares that this Bluetooth headset with a charging
case complies with Directive 2011/65/EU updated from 2015/863/EU.
INFORMATION ON THE STATUTORY WARRANTY
Our products are covered by a statutory warranty against conformity defects in
accordance with applicable national consumer protection laws.
For more information, please see the following page
https://www.cellularline.com/en/garanzia-legale
INSTRUCTIONS FOR THE DISPOSAL OF DEVICES FOR DOMESTIC USE (Applicable in countries in the European Union and those with separate waste collection systems) This mark on the product or documentation indicates that this product must not be disposed of with other household waste at the end of its life. To avoid any damage to health or the environment due to improper disposal of waste, the user must separate this product from other types of waste and recycle it in a responsible manner to promote the sustainable re-use of the material resources. Domestic users should contact the dealer where they purchased the product or the local government office for all information regarding separate waste collection and recycling for this type of product. Corporate users should contact the supplier and verify the terms and conditions in the purchase contract. This product must not be disposed of along with other commercial waste. This product has a battery that cannot be replaced by the user. Do not attempt to open the device to remove the battery as this could cause malfunctions and seriously damage the product. When disposing of the product, please contact the local waste disposal authority to remove the battery. The battery inside the device was designed to be able to be used during the entire life cycle of the product. For more information, visit the website http://www.cellularline.com
Using the device may, in some cases, interfere with the correct functioning of
medical devices (e.g. pacemakers).
Prolonged exposure to high volume and prolonged use may cause permanent damage
to hearing.
Do not use the device in places where being unable to hear external noises
could prove dangerous (e.g. railway crossings, train platforms)
If used when driving, comply with the regulations in force in the relevant
country.
Children should be supervised when using the device and all accessories and
packaging should be kept out of their reach.
Do not expose the device for prolonged periods to dampness, dust, soot, steam,
direct sunlight, and excessively high or low temperatures, which could result
in it malfunctioning Use only suitable chargers for charging
Regularly charge the product (at least once every 3 months).
Via Lambrakis 1/A
42122 Reggio Emilia, Italy
www.cellularline.com