JETBOIL 813623 Zip Cooking System Instruction Manual

ZIP Cooking System Instructions

Important: Read these warnings and instructions carefully prior to assembling or using this product. Fully familiarize yourself with this product before connecting it to a fuel canister. Keep these instructions for future reference.

DANGER
ONLY USE OUTDOORS IN A WELL-VENTILATED AREA IN ORDER TO AVOID ENDANGERING YOUR LIFE

WARNING
FIRE OR EXPLOSION HAZARD If you smell gas:

1. Do not attempt to light appliances.
2. Extinguish any open flame.
3. Disconnect from the fuel supply.
4. Evacuate immediately.
5. Allow gas to dissipate 5 minutes before relighting the appliance.
   Failure to follow these instructions could result in fire or explosion, which could cause property damage, personal injury, or death.| DANGER
   ---|---
   CARBON MONOXIDE HAZARD
   This appliance can produce carbon monoxide which has no odor.
   Using it in an enclosed space can kill you.
   Never use this appliance in an enclosed space such as a camper, caravan, tent, car, mobile home, marine craft, or home.  

FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WARNING

• Do not modify this appliance. This may be hazardous and will void the warranty.
• Burn Hazard – Accessible parts may become very hot.
• Burn Hazard – Keep away from children.
• Do not leave the stove unattended while in use.

SPECIFICATIONS

Gas category: Direct Pressure – Butane-Propane mixture. The canister must conform to the EN417 or AS2278 standard. This appliance is only intended for use with  00g/230g/450g Jetboil Jetpower Isobutane/Propane Fuel Canisters (sold separately). It may be hazardous to attempt to fit other types of gas containers. Jet Size: 0.21mm Gas   Consumption: 5 MJ/hr (AU) || 65 g/hr [0.9 kW] (EU) || 4,500 BTU/hr (CA)

LEAK CHECK PROCEDURE

1. Perform leak checks outside, in a well-ventilated area.

2. Connect fuel canister (3.1) to valve (3.2) by threading in the orientation shown in Fig 4.

3. Put soapy water on the gas connection between the fuel canister and the valve. The formation of bubbles indicates a gas leakage.
   WARNING
   Do not check for leaks using a flame.
   WARNING
   If a leak is detected, do not attempt ignition. Remove fuel canister immediately and contact Customer Service.

4. If no leak is found, detach the fuel canister. The leak check is complete.

FIGURES

ASSEMBLY

WARNING

• Perform Leak Checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials and ignition sources.
• Before each use: Keep stove area clear and free from combustible materials, gasoline, and other flammable vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air to the stove.
• Do not use a windscreen or an outback oven; this can overheat the fuel canister, resulting in an explosion.
• Do not use an appliance that is leaking, damaged, or which does not operate properly.
• Always change gas canisters in a well-ventilated location away from any sources of ignition, such as naked flames, pilot, electric heaters/equipment and away from other people.

1. Remove packed contents from the pot (Fig 1).

2. Perform LEAK CHECK PROCEDURE (See Page 5).

3. Close the control valve (8.1) (turn clockwise).

4. Check for debris in the valve connection (1.1), and that the O-Ring is in place and in good condition before connecting to the stove.
   WARNING Do not use the appliance if it has damaged or worn seals, this may result in ingas leakage.
   WARNING In temperatures below freezing, O-Rings may not seal fully, resulting in a fuel leak.

5. To check that the gas canister is not empty, liquid fuel may be heard and/or felt inside when the canister is shaken.

6. Connect fuel canister (3.1) to valve (3.2) by threading in the orientation shown in Fig 4.
   WARNING Hand tighten only, do not over-tighten or cross-thread. May damage seals resulting in a fuel leak.

7. Unfold stabilizer legs (2.1) and securely attach the stabilizer to the fuel canister (Fig 5).

8. Place the assembled stove on a flat, level surface, at least 1m/3.3ft away from any combustible materials or ignition sources.

9. If using Pot Support (sold separately): Unfold pot support legs (12.1), place it on top of burner base, and rotate to lock (12.2). Confirm that support is fully attached, seated, and stable.
   WARNING Never use alternate cookware without the Jetboil Pot Support. Failure to use the Pot Support will result in a fire that may cause death or serious injury.
   WARNING Never use cookware larger than 2L capacity or 9in. [23cm] diameter when using a Pot Support.

OPERATING INSTRUCTIONS

WARNING

• Keep the burner at arm’s length, away from the face, during ignition. Flame can flare during ignition.
• Do not attempt to light with included pot or any other cookware on the burner. Gas build-up can occur, resulting in increased flame eruption.
• Never expose the stove to flammable vapors or liquids while lighting the burner. It can cause an explosion or fire.
• Do not heat an empty pot. The product will melt and potentially catch fire.
• Do not move, lift, or tilt the stove with a lit burner. Product damage or injury can occur due to flaring.
• Do not fill above the maximum fill line. This may cause boil-over, resulting in injury.
• If attempting to heat anything other than water, use care and stir frequently to avoid boil over or scorching, which may result in product damage or injury.
• Always check that the burner is extinguished before disconnecting the fuel canister.
• Do not use for boiling oil or deep frying. Product damage or injury can occur due to overheating.

Preparation:

1. Remove bottom cover (7.1) from the bottom of the Jetboil pot (7.2).
2. Remove Pot Support Warning Tag.
3. Add contents to the pot, cover with lid, but do not put the pot on the stove yet. Now you are ready to light the burner.
   NOTICE Performance may be suboptimal if used in extreme conditions (cold, hot, wind, altitude).
   WARNING Do not use the stove to warm the fuel canister. Can result in an explosion.

Lighting the Burner:
CAUTION
Ensure burner base is free of any pot prior to lighting. Gas build-up can occur, resulting in increased flame eruption.

1. Hold lit match or lighter over top of burner (Fig 9).
2. Open control valve (8.1) counterclockwise until the burner is lit.

Usage:

1. If necessary, rotate the control valve (8.1) clockwise to decrease the flame setting.
2. Once the burner is lit, carefully place the pot with its contents on the burner base (Fig 10); turn as shown in Fig 11 to lock into place.
   CAUTION
   Use care when removing the lid. Steam and/or contents may be hot and can cause injury.

AUCTIONS

After Use:

1. Turn off the control valve (8.1) (tighten clockwise) to extinguish the flame.

2. Remove pot from burner base – hold the pot by cozy (10.1), and base by a shroud (10.2).
   WARNING Exposed metal parts will be hot and may cause injury if touched.

3. Always disconnect the fuel canister after use. Unscrew fuel canister from burner base (Fig 4), and replace plastic fuel cap.
   WARNING Always check that the burner is extinguished before disconnecting the fuel canister. Vapors can ignite and cause serious injury.

Packing:

1. Allow the stove to fully cool before packing.
2. Place bottom cover (7.1) on the pot (7.2).
3. Remove stabilizer from the canister and fold for storage (1.2). 4. If using the pot support: Remove pot support from burner base (Fig 12), and fold legs (1.4). 5. Refer to Fig  1 for packing contents into the pot.

Storage After Use:

1. Always disconnect the fuel canister before storing the stove. 2. Ensure the stove and pot are clean and dry before storing. 3. Store the stove in a cool, dry location, indoors.

Maintenance:

1. Flame Check (Every use) : The height of the flame should increase from low to high with counter-clockwise rotation of the control valve. The flame should be blue with no yellow tipping at full output. The flame should not flashback into the burner or lift-off of the burner top. If flame abnormalities are found, see your dealer or contact Jetboil for service.
2. Cleaning Pot (before storage, or as needed): Allow the pot to cool before cleaning. Do not use a dishwasher or abrasive compounds (sand, salt, etc.) to clean. Only wash by hand with soapy water.

Troubleshooting:

1. Flame does not extinguish: Tighten valve as much as possible, blow out the flame, and immediately detach fuel source. See your dealer or contact Jetboil for service.
2. If an issue cannot be corrected using these instructions, see Limited Warranty on the back page.

WARRANTY/SERVICE INFORMATION
This appliance must only be serviced by an authorized person.
Contact your local dealer, distributor, or Jetboil for parts and/or service.
Please visithttp://www.jetboil.com/warranty
for product warranty information.
Jetboil Johnson Outdoors Gear, Inc.
540 N. Commercial St.
Manchester, NH 03101
1.800.572.8822jetboil.com V12

Documents / Resources

| JETBOIL 813623 Zip Cooking System [pdf] Instruction Manual
813623, Zip Cooking System
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>