hama 00081380 Delta Ovum LCD Universal Charger Instruction Manual

hama 00081380 Delta Ovum LCD Universal Charger Instruction Manual

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the  device, please pass these operating instructions on to the new owner.
If you sell the device, please pass these operating instructions on to the new owner.

Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note

This symbol is used to indicate additional information or important notes.

Package Contents

• 1 Delta Ovum LCD universal charger
• 1 100 V-240 V adapter
• 1 12 V car charging cable
• These operating instructions

Safety Notes

• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Do not operate the product outside the power limits given in the specifications.
• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Only connect the product to a socket that has been approved for the device. The socket must be installed close to the product and easily accessible.
• Disconnect the product from the network using the power button – if this is not available, unplug the power cord from the socket.
• Lay all cables so that they do not pose a tripping hazard.
• Do not bend or crush the cable.
• Do not drop the product and do not expose it to any major shocks.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Keep this product, as all electrical products, out of the reach of children!
• Dispose of packaging material immediately according to locally applicable regulations.
• Do not modify the product in any way. Doing so voids the warranty.
• Do not use power supply units that are not recommended by the  manufacturer.

Electrical shock hazard

• Do not use the product if the power supply unit or power cable are damaged.
• Do not attempt to service or repair the device yourself. Leave any service work to qualified professionals.
• Do not open the device or continue to operate it if it becomes damaged.

Warning – Batteries

• Do not attempt to charge any Li-ion batteries with voltages above or below the voltage range specified for this charger. This can damage the charger.
• Do not attempt to charge any non-rechargeable batteries (e.g. alkaline) or any batteries which are damaged, leaking or corroded.

Note

• When using this product, observe the applicable local traffic laws and regulations.
• Take care that components such as airbags, safety areas, controls, instruments, etc. and visibility are not blocked or restricted.

Getting Started and Operation

• Connect the charger to one of the two possible power supplies (Pic. 1).
  
  Note:

  • The charger automatically recognises faulty batteries and does not charge these for safety reasons.
  • When the power supply is active, “power” appears in the display. The charger is now ready for use.
  • Charging rechargeable batteries: While batteries are being charged, their charge level is shown. Steady bars on the charge level indicator indicate the current charge level; the flashing bar indicates charging in progress. When all 3 bars are steady, the corresponding battery or batteries are fully charged.
  • Charging USB terminal devices: While a USB terminal device is being charged, all 3 bars flash. Read the current charge level from your terminal device. If the USB output current is less than 90 mA, then nothing is shown on the display. The display is activated only if the USB output current is more than 90 mA.
  • Charging rechargeable batteries and a USB terminal device: While rechargeable batteries a USB terminal device are being charged simultaneously, the charge level of the batteries is displayed.

• Remove batteries from the charger once they are fully charged.

• Disconnect all cable and mains connections after use.

Note

• For some vehicle types, the ignition has to be switched on to supply power to the 12 V car socket.
  For more information, please refer to your vehicle’s manual.

• The charger is suitable for a mains voltage of 100-240 V and can be used around the world.
  Please note that a country-specific adapter may be necessary.

• You can find an appropriate selection of Hama products at www.hama.com.

Charging Li-ion batteries

• Open the slide cover of the charger completely until it locks into place.

• Adjust the contacts on the bottom of the charger to fit the particular Li-ion battery to be charged (Pic. 2). Adjust the contacts so that one lies against the – pole and the other lies against the + pole of the rechargeable battery.
  

• Insert the battery into the charger (Pic. 3). The charger automatically recognises the polarity of the Li-ion battery.

• Unlock the sliding cover by pressing the red unlock button. Close the cover so that the battery is held firmly between the contacts.

• If the display does not show the charge level correctly, check and adjust the contacts.

Charging NiMH batteries (AA/AAA cells)

• Open the slide cover of the charger completely until it locks into place.

• When charging NiMH batteries, observe the correct polarity indicated on the battery symbols. Insert the NiMH battery with the correct polarity (Pic. 4).
  

• Unlock the slide cover by pressing the rote release button and then close the slide cover so that the particular battery is held securely and is touching the contacts.

• If the display does not show the charge level correctly, check and adjust the contacts.

• Only one type of battery (AA or AAA) may be charge at the same time. Varying battery charge capacities (as measured in mAh) are of no concern.

USB charging option

• Connect the terminal device to be charged to the USB port of the charger directly or using a suitable USB cable. (Fig. 5) “USB power” appears in the display.
  

• Charging of the terminal devices begins and ends automatically.

• The display reads as described in 4. Getting Started and Operation

Warning – Connecting terminal devices

• Before connecting a terminal device, check whether the power output of the charger can supply sufficient power for the device.
• The USB charging option supplies a maximum of 5 V 1000 mA.
• Please refer to the operating instructions for your terminal device.
• It is essential that you observe these specifications and the safety instructions regarding the power supply of your devices.

Simultaneous charging

Whether the power supply comes from mains power or a vehicle charging cable, you may simultaneously charge a Liion/NiMH rechargeable battery and a USB terminal device.

Warning – Batteries

Do not charge both a Li-ion and a NiMH battery simultaneously.

Note

Charging batteries and a USB terminal device at the same time using a vehicle charging cable may result in longer charging times.

Care and Maintenance

Only clean this product with a dry, lint-free cloth and do not use aggressive cleaning agents. Make sure that water does not get into the product.

Warranty Disclaimer

Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Service and Support

Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here: www.hama.com

Technical Data

–

| Universal charger Delta Ovum LCD
---|---
Power supply unit| In : 100–240 V~ 50 /60 Hz 500 mA
Out : 12,0 V 1,0 A 12,0 W
Vehicle charging cable| 12 V (with F1,6A fuse)
Charger input voltage| 12 V  1000 mA
Charger output voltage| Li-Ion 4,2 V 650 mA
Li-Ion 8,4 V 650 mA NiMH (AA/AAA)
1x/2x 1,4 V 650 mA
USB 5V 1000 mA
Operating temperature| 0-40°C
Speci fi cations in accordance with Regulation (EU) 2019/1782

Manufacturer’s name or trade mark, commercial registration number and address| Hama, HRA12159,
Dresdner Str. 9,
86653 Monheim
Model identifier| JT-H120100E
Input voltage| 100 V-240 V
Input AC frequency| 50 Hz / 60 Hz
Output voltage / Output current / Output power| 12.0 V DC/ 1.0 A/

12.0 W

Average active efficiency| 83.9 %
Efficiency at low load (10 %)| 76.28 %
No-load power consumption| 0.0582 W

Recycling Information

Note on environmental protection:

After the implementation of the European Directive 2012/19/EU and 2006/66/EU in the national legal system, the following applies: Electric and electronic devices as well as batteries must not be disposed of with household waste.
Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations.
By recycling, reusing the materials or other forms of utilising old devices/Batteries, you are making an important contribution to protecting our environment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>