CQR SO/ALTO/WH/G Combined Internal Sounder and Extension Speaker Instruction Manual
- June 6, 2024
- CQR
Table of Contents
CQR SO/ALTO/WH/G Combined Internal Sounder and Extension Speaker
Low profile design.
110 dB sound output.
Selectable alternating or continuous tone. Low current consumption.
Tamper protected lid and mounting.
Description
This remotely powered internal sounder can be installed in security systems up to and including Grade 3 Environmental class II in accordance with EN50131:2006 + A1:2009. It is certified by Telefication to EN50131-4:2009. The warning device gives an audible signal of alarm activation. The sound output is selectable for either alternating or continuous tone. It is also protected against tampering by means of lid removal and removal from the mounting surface.
Features
Mounting Instructions
Identify a suitable mounting location for the sounder on a flat wall. To remove the lid, unscrew the retaining screw on the front face, grip both sides and hinge the lid up as shown opposite. Using the sounder as a template, mark the fixing points on the surface of the selected location. Drill 4 x 5mm holes for the enclosed wall plugs, insert the wall plugs into the holes, feed the cable through the cable entry point on the sounder and using the enclosed screws, fix the sounder to the selected location.
Please note in order for the sounders tamper protection to detect unauthorised removal from the mounting surface, the tamper fixing screw hole must be used, do not overtighten this screw as this is a one time operation and if broken or damaged the sounder will need to be replaced.
Wiring Options
There are five
terminals for the connection of wires as shown above. To activate either the
alternating or continuous sound, connect a negative to the common negative
terminal (GND) and connect a positive to the appropriate positive terminal (#1
or #2). To stop the sound, remove the positive or negative supply.
Please note that continuous tone does not comply with EN50131-4.
Connection Examples
1 = Continuous Sound +ve
2 = Alternating Sound +ve
GND = Common -ve
Tamper x 2 = Lid and mounting surface tamper.
Specifications
Technical
Nominal Voltage: 13.6 volts DC
Voltage range: 9-15 volts DC
Sounder Type: Tone (Piezo)
Sound output level : 110 dB (A) @ 1 metre
Continuous Sound only current: 107mA @ 13.6 volts dc
Alternating Sound only current : 90mA @ 13.6 volts dc
(110mA @15 volts dc/ 80mA @ 9 volts dc)
Temperature Range: -15° C to +40° C
Sound Duration: Determined by the control panel.
Tamper Detection
Lid and mounting surface removal.
Housing
Base Material: ABS
Lid Material: ABS
Dimension (mm): 115mm x 115mm x 32mm
EN50131-1:2006 + A1:2009
: Security Grade 3 Environmental Class II
EN50131-4:2009
Warning device type: Internal Remotely Powered
Safety Precautions
Always observe local regulations when disposing of this unit Plastic bags can suffocate, always dispose of packaging carefully
Environmental Advice.
This product is covered by current WEEE regulations. Please consider the
effect on the environment when disposing of it. Do not put in a domestic waste
bin. Only dispose of at an appointed recycling centre.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>