CQR PADP2 Double Push Panic Button Instruction Manual
- June 15, 2024
- CQR
Table of Contents
CQR PADP2 / SS /G1
Rev.1
PA Overview
- Key Reset Hole
- Push Buttons
- Front Cover
- Indicator
- Backplate
Installation Instructions
Mounting
Undo the two cover screws to remove the front cover from the Backplate.
Fix Backplate to mounting surface using suitable fixings.
Wiring
Route the cable through the access holes in the rear of the Backplate.
Connect control panel PA zone/circuit to the two reed switch terminals inside
the PA Button (not polarity conscious) as shown below.
Refit cover to PA Backplate.
Backplate Diagram
- Extra Terminals
- Mounting holes
- Connect wiring to Control Panel PA circuit / zone
Note: Three extra terminals are provided for terminating other circuit wires.
Operation
To Operate Press both red buttons simultaneously. Indicator will show RED.
To Reset Insert supplied key into front cover and turn clockwise
through 90°. Indicator will show Yellow. Remove key.
Note: Remove key from PA button whilst not in use and store
carefully.
Specification
Operation Double Push
Material ABS
Switch Reed
NO/NC Configuration Both
Terminals 5
Tamper None
Reset Latch
Indicator Yes
Backlit No
Max Voltage 50v DC
Max Current 500mA
Security Grade 1
Environmental Class II
Dimensions (w) x (h) x (d)mm 62 x 75 x 30
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>