SGILE SEY-2102 Race Car User Manual
- June 6, 2024
- SGILE
Table of Contents
- SGILE SEY-2102 Race Car
- Part list
- Controller Battery Installation
- Battery Installation And Charging
- Battery Use Installation And Cautions
- Car Operation
- Care And Maintenance
- WEEE Compliance
- DECLARATION OF CONFORMITY
- FCC COMPLAINCE STATEMENT
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
SGILE SEY-2102 Race Car
Part list
- 1 x Vehicle
- 1 x Remote Controller
- 2 x 3.2V 1500mAh Lithium Battery
- 1 x USB Charge Cable
- 1 x User Manual
Controller Battery Installation
- Open the battery cover using the screwdriver.
- Load two 1.5V AAA batteries following the polarity markings(+ and -) inside the battery compartment.
- Replace the battery cover and tighten the screws.
Battery Installation And Charging
- Connect the battery wire with the USB charging cable. then connect the USB charging cable to computer to charge the battery.
- The charging time is about 2 hours. The play time is 25-00 minutes on a full charge.
- LED light turns off when charging (Overvoltage protection).LED light turns green when it’s fully charged (Standby mode/short circuit protection).
- Use the screwdriver to loosen the screws and remove the battery compartment cover,
- Connect the battery’s connector with the compartment’s connector, then insert the battery Into the compartment, Refit the cover and fasten the screws to complete the installation.
Note:
Charging the battery before the first time you use tt. The battery might
discharge if not in use for a long period of time. However, over-discharge may
damage the lifetime of the battery. Inspect the charging cord, plug, housing
and other parts on a regular basis. If you find something damaged, please
immediately stop using it and fix the damaged part.
WARNING: For the purposes of recharging the battery, only use the detachable supply unit provided with this toy, Unplug the USB cable after charging to avoid power loss.
The appliance is only to be used with the power supply unit provided with the
appliance. The use of a different power supply unit may lead to the permanent
damage of the battery and neighboring parts, as well as a physical injury!
Battery chargers used with the toy are to be regularly examined for damage to
the cord, plug, enclosure and other parts, and in the event of such damage,
they must not be used until the damage has been repaired, This toy Is only to
be connected to equipment bearing either of the following symbols: IQ) or
Battery Use Installation And Cautions
- Non-rechargeable batteries should not be charged.
- Rechargeable batteries are only to be charged under adult supervision (for toys supplied).
- Rechargeable batteries are to be removed from the toy before being charged.
- Different types of batteries or new and used batteries are not to be mixed.
- Batteries are to be inserted with the correct polarity
- Exhausted batteries are to be removed from the toy,
- The supply terminals are not to be short-circuited
- The new Lithium battery packs need to be charged before using,
- Make sure the main switch is set lo OFF before installing the battery pack into the car body.
- Remove battery from the transmitter when not use for a long time.
- Dispose of used battery to recycling center or designated place.
- Adult installation required.
Car Operation
Care And Maintenance
- Use the original USB cable and rechargeable batteries. Charging by compu1er is recommended.
- WARNING! Do not use the SGILE RC vehlcle in road traffic,
- Do not use the SGILE RC vehicle for transporting goods, persons or animals,
- Never use the SGILE RC vehicle outdoors during rain or snowfall. The car must not be run through water, puddles and snow, and must always be kept stored in a dry place.
- Avoid running on courses which are laid exclusively with sand.
- Do not expose the SGILE RC vehicle to direct sunlight.
- Never subject the SGILE car to repeated changes of load• that means continuously reversing it.
- Never throw the car on the floor lrom a standing position.
- The SGILE RC vehicle must be Inspected before and after operation, each time It is used, to ensure that It has not become disassembled, Any screws or nuts that may have become loosened during operation must be tightened.
WEEE Compliance
Please help the environment by disposing of your product responsibly at the
end of its life. The wheeled bin symbol indicates that this product should not
be disposed of in your household waste
containers. Instead, the product should be disposed of by using a designated
collection point for the recycling of waste electrical and electronic
equipment, The Waste of Electrical and Electronic
Equipment(WEEE) Directive (2012/19/EU) requires that the best available
recycling techniques be
employed to minimize the impact on the environment. Recycling electronics
helps by keeping harmful chemicals out of the environment, and also saves
money by reusing precious metals.
Remove any batteries and dispose of them and the product at your local
authority recycling facility, For more information about where you can drop
off your waste equipment for recycling, please
contact your local city office, your household waste disposal service or the
location where you purchased this product.
DECLARATION OF CONFORMITY
Hereby, Fujian EastWest Lifewit Technology Co., L TO declares that the radio
equipment type NO.SEY·2102 is in compliance with Radio Equipment Regulations
2017. The full text of the UK declaration ol conformity is available at the
following
internet address: https://www.sgile.com/pages/compliance.
Maximum radio-frequency power transmitted: <3dBm
Frequency range: 241 0MHz-2.473MHz
FCC COMPLAINCE STATEMENT
FCC ID: 2AZNY-SEY-2102
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modifications not expressly approved by the party responsible for compliance could void the uses authority to operate the equipment.
WARNING
This toy contains small parts which can be swallowed and is therefore not
suitable for children under 3 years of age.
WARNING! danger of pinching during operation! Remove all packaging
materials and wire fastenings before handing the toy over to the child. Please
retain the packaging and address for information and in the event of any
questions.
CHOKING HAZARD – small parts not suitable for children under 3 years.
US RESPONSIBLE PERSON: EASTWEST ELECTRONIC COMMERCE CO US LIMITED
ADDRESS: 3500 SOUTH DUPONT HIGHWAY, DOVER, DE 19901
UK RESPONSIBLE PERSON: LIFEWIT LIMITED
ADDRESS: FLAT 237,233 HIGH STREET CROYDON SURREY, ENGLAND CAO 1 FY, UNITED
KINGDOM
EU RESPONSIBLE PERSON: UFEWIT GmbH
ADDRESS: LUOWIGSTRASSE 278, 97070 W0RZBURG MANUFACTURER: Fujlan EastWest
Lttewit Technology Co.,LTD ADDRESS: Rm 1201-1205, Bid 18, 2nd Phase of
Innovation Park, no,7, Wulongiiang Middle Avenue, Fuzhou High-tech Zone,
Fuzhou, Fujian Province
MADE IN CHINA
IN CHINA HERGESTELLT FABRIOUE EN CHINE FATTO IN CINA
HECHO EN CHINA GEMAAKT IN CHINA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>