GTRS CA5 Guitar Amplifier Owner’s Manual
- June 6, 2024
- GTRS
Table of Contents
GTRS CA5 Guitar Amplifier
Precautions
PLEASE READ CAREFULLY BEFORE USING
PowerSupply
- Please use a power supply that meets UL, CSA, VED, or CCC standards
- Please use the power supply that meets manufacturer’s power requirement
- Please unplug the power supply when the device is turned off or a during thunderstorm
- Please do not expose the device which has battery power to heat or let it overheat
- If battery leakage occurs, please do not touch the liquid with your skin or eye. If you do come in contact, please see a doctor
- The battery included with with the device may cause fire or chemical burns if handled improe_erly
Location
To avoid deformation, discoloration, or other serious damage, do not expose this unit to the following conditions:
- Direct sunlight
- Extreme temperature or humidity
- Excessive dusty or dirty location
- Magnetic fields
- High humidity or moisture
- Strong vibrations or shocks
Cleaning
Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth. Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents, cleaning fluids, or chemical-impregnated wiping cloths.
Operation
- Please do not toggle the switch, rotate the knob heavily.
- Please do not let the paper scrap, metal debris or other sundries falls inside the unit.
- Please do not let the unit fall from high level, or push, strike the unit heavily.
- Please do not modify the unit without authorization.
- For repairing service, please contact MOOER support team for more information.
Layout
A. Power Switch with LED to indicate on/off status
B. Bass frequency holes
C. l/4″instrument input
D. USB Charging port
Instructions
-
On/off
Rotate the power switch clockwise until the LED on the device turns on. Rotate the power switch counterclockwise until the switch LED is off to turn off the device. -
Volume Level Adjustment
Power on the device and rotate the power switch to adjust the volume level. -
Bluetooth
Turn on the device and Bluetooth will be on as well. Turn on the Bluetooth of your mobile device and search for “GTRS PTNR”, confirm connection to play the music from the mobile device. -
Charging
The switch LED will blink to indicate low-battery-life status when the unit is on. Please charge the unit via theUSB-C charging port. After charging is complete, the switch LED will stop blinking.
Note: For the best sound experience, please charge the device in time when the low battery alarm appears, to avoid the distortion tone caused by low power status.
Specifications
| Input | 1/4″ Monoaural jack (impedance value: 20) |
|---|---|
| Speaker | 2.2″*1 speaker (impedance value 40), bass frequency vibrating |
diaphragm
Power| 5W
Battery capacity| 2000mAh
Charging requirements| 5V 1A
USB cable support| USB-C to USB-A cable, USB-C to USB-C cable
Duration| ≥ 7 hours
Bluetooth version| 5.0
Weight| 0.54kG
Dimension| 130mm (D) X 104mm (W) X 75.Smm(H)
Accessories| Owner’s manual, USB cable
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.