Baseus CGZX000001 Wisdom Auto Alignment Car Mount Wireless Charger User Manual
- June 6, 2024
- Baseus
Table of Contents
Baseus CGZX000001 Wisdom Auto Alignment Car Mount Wireless Charger
Baseus Wisdom Auto Alignment Car Mount Wireless Charger（QI 15W）
Please read this user manual carefully before use and keep for future reference.
Product Introduction
1. Indicator bar
2. Left/Right clamp arm
3. Type-C port
4. Knob
5. Tail clamp hook
6. Tail clamp knob
7. Clamp arm turn-on switch
8. Wireless charging area
Instructions
Product Installation
1. Turn the knob to extend the tail clamp hook.
2. Select an appropriate air outlet position. Hook the air outlet grating with the tail clamp hook. Tighten the knob until the support does not sway. (Do not tighten the knob too tight. Ensure that the air outlet is strong enough to support the torque.)
3. Release the knob. Press the ball head into the ball head groove. Adjust the support angle (the line of sight should be vertical to the support surface). Tighten the knob.
4. Connect the power cord.
5. Place the mobile phone so that the support automatically clamps the mobile phone.
6. Touch the switch and the support will open. Take out the mobile phone.
Product Parameters
Product model: CGZX000001
Input: 5 V/2 A 9 V/2 A 12 V/1.67 A
Output: 15 W (Max)
Light Indication
Charging: The indicator breathes.
Full charging: The indicator is steadily on. Abnormality: The indicator blinks fast.
(Abnormalities: FOD alarm, overvoltage protection, undervoltage protection and high temperature protection)
Tips
1. Use a 5 V/2 A, 9 V/2 A or 12 V/1.67A adapter.
2. If there is any metal between the wireless charging area and the mobile phone during charging, the phone cannot be recharged.
3. The operating environment temperature shall be maintained at 0-25℃. Too high or too low temperature will affect the wireless charging efficiency.
4. Pay attention to how tight it is installed to avoid damage to the air outlet during the installation.
5. Immediately reinforce a loose support after long-term operation.
6. The wireless charging coupling distance is 6 mm. The use of a thick mobile phone shell will affect the wireless charging efficiency.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help. FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>