MINELAB 0039A Metal Detector Instructions

June 6, 2024
MINELAB

INSTRUCTIONS AND
SAFETY INFORMATION

ADVICE AND SAFETY INSTRUCTIONS
For complete product specification and operational guidance, read the full- length Instruction Manual at www.minelab.com/knowledge-base/product- manuals Alternatively, please contact us to make alternative arrangements for a copy.
ASSEMBLY INSTRUCTIONS
For guidance on detector assembly, please refer to the Getting Started Guide included or visit the Knowledge base online: www.minelab.com/knowledge-base /product-manuals. The Minelab website also provides information on accessories available for your detector.
WARRANTY TERMS
Please refer to www.minelab.com/warrantyconditions for full warranty terms and conditions. Register your product warranty online atregister.minelab.com.
SAFETY CONSIDERATIONS

  • Keep out of reach of children, small parts are choking hazard.
  • Do not mutilate the batteries.
  • Dispose of batteries as per local regulations.
  • Only charge the detector and accessories according to the instructions in the manual.
  • Do not dispose of the detector or accessories in a fire.
  • Disconnect coil and battery before packing/storing as luggage.
  • CAUTION — Risk of explosion if the battery is replaced by an incorrect type.

REGULATORY INFORMATION
Federal Communications Commission (FCC) Statements (as applicable)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Part 15.105 NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into and outlet a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Compliance Statements for Canada (as applicable)
This product meets the applicable Innovation, Science, and Economic Development Canada technical specifications.
RSS-Gen notice:
This device complies with Industry Canada’s license-exempt RSS. Operation is subject to the following two conditions: 1) This device may not cause interference; and 2) This device must accept any interference, including interference that may cause undesired operation of the device.
Modification
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device. Simplified EU Declaration of Conformity Hereby, Minelab Electronics Pty Ltd declares that the radio equipment type [Refer to detectors listed in Table 1] complies with Directive 2014/53/ EU. The full text of the EU declaration of conformity is available at the following internet address: www.minelab.com/compliance. License/ Permit The equipment operator is responsible for
investigating and obtaining any required local license or permit for metal detecting activities.
US Responsible Party
Minelab Americas Inc: 123 Ambassador Drive, Suite 123
Naperville, IL 60540, USA
www.minelab.com
Table
CERTIFICATION SCHEME ID

Detector| FCC 10| Anatel| Japan MIC| KC| ISE0| NOM/NYCE
---|---|---|---|---|---|---
VANQUISH 540| Z4C-0041| TBC| 001-A16239| R-C-Tej-0041| 24927-0041| NYC- 2002C0E08969
VANQUISH 340/440
EQUINOX 600/800
X 3030| R-R-Tej-0041A| ICES-3(B)/NMB-3(13]
| | | R-CMM-Tej-
EQUINOX900| 24927-0022| NYC-2002C0E08966
Z4C-1010| | | —| —| NYC-2002C0E08946
00-FIND 44/88| Z4C 2660| TBC| 3180016| R-CMM-Tej-
GO-FIND66| 24927-2860| NYC-2002C0E09969
130-FINO 11/22| ICES-3(eI/rime-3M| NYC-2002C0E09969
Safari| —| | —| —| —
Excalibur II| —| TBC| —| R-R-Tej-0454| —| NYC-2002C0E09754
E-TRAC| —| —| —| —| —| —
X-TERRA Series| —| —| —| —| —| —
PRO-FIND 15/20/35| —| TBC| —| R-R-Tej-0018| ICES-3(B)/NMB-3(B)| NYC- 2002C0E08970
Gold Monster 1000| —| 06B76-1B-11695| —| R-R-Tej-0019| ICES-3(B)/NMB-3(B)| NYC-2002C0E09969
SOC 2300
GPZ 7000| —
Z4C-7000| 05531-20-11695
05965-18-11695
TBC
TBC| —


—| R-R-Tej-0012| —| NYC-2002C0E08968
—| —| NYC-2002C0E08946
SPX 5000| —| —| —| —
SPX 8000| Z4C-0039A| R-C-Tej-0039| ICES-1(B)/24927-0039A NMB-1(B)| NYC- 2002C0E08968

Table
RADIOFREQUENCY SPECIFICATION

Detector Bluetooth stream
Detector Frequency Power

VANQUISH
340/440/540| 5 to 143 kHz| < -30 dBm| 2.4 to 2.5 GHz| 0 dBm| —| —
EQUINOX 600/800| 3.7 to 143 kHz| < -30 dBm| 2.4 to 2.5 GHz| -5.9 dBm| 2A to 2.5 GHz| -0.5 dBm
CTX 3030| 1.3 to 141 kHz| < -30 dBm| —| —| 2.4 to 2.5 GHz| 14 dBm
GO-FIND Series| 7.4 to 8.2 kHz| < -30 dBm| 2.4 to 2.5 GHz| 8.9 dBm| —| —
Safari| 1.3 to 141 kHz| < -30 dBm| —| —| —| –
Excalibur II| 1.3 to 141 kHz| < -30 dBm| —| —| —| –
E-TRAC| 1.3 to 141 kHz| < -30 dBm| —| —| —| —
X-TERRA Series| 2.7 to 20 kHz| < -30 dBm| —| —| —| –
PRO-FIND 15/20/35| 11 to 13 kHz| < -30 dBm| —| —| —| —
Gold Monster 1000| 43 to 46.8 kHz| < -30 dBm| —| —| —| —
SW 2300| 3.5 to 146 kHz| < -30 dBm| —| —| —| –
BPZ 7000| 118 to 147 kHz| < -30 dBm| —| —| 2.4 to 2.5 GHz| 0 dBm
BPX 5000| 1.1 to 145 kHz| < -30 dBm| —| —| —| –
BPX 6000| 118 kHz to 147 kHz| < -30 dBm| 2.4 to 2.5 GHz| +4dBm| —| —

Certification and logo usage depends on product and region
Minelab Electronics, PO Box 35 Salisbury South, South Australia 5106

Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries. Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other countries.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals