MINELAB ML105 Wireless Headphone User Manual
- June 10, 2024
- MINELAB
Table of Contents
ML105 Wireless Headphone
User Manual
ADVICE AND SAFETY INSTRUCTIONS
For complete product specification and operational guidance, read the
Instruction Manual at www.minelab.com/product-manuals.
Alternatively, please contact us to make arrangements for a copy.
ASSEMBLY INSTRUCTIONS
For guidance on detector assembly, please refer to the Getting Started Guide
included or visit: www.minelab.com/product-manuals.
The Minelab website also provides information on accessories available for
your detector.
WARRANTY TERMS
Please refer to www.minelab.com/support/product- warranty for full warranty terms and conditions. Register your product warranty online at register.minelab.com.
SAFETY CONSIDERATIONS
- Keep out of reach of children, small parts are a choking hazard.
- Do not mutilate the batteries.
- Dispose of batteries as per local regulations.
- Only charge the detector and accessories according to the instructions in the manual.
- Do not dispose of the detector or accessories in a fire.
- Disconnect coil before packing/storing as luggage.
- CAUTION — Risk of explosion if battery is replaced by an incorrect type.
- CAUTION — Only charge the battery in ambient temperatures between 0°C and 40°C.
- Headphone use at HIGH volume may cause reduced awareness of surroundings and could lead to hearing damage. Use at lower volumes advised.
- Adult supervision required when used by children.
REGULATORY INFORMATION
Federal Communications Commission (FCC)
Statements (as applicable)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Part 15.105
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
US Responsible Party: MINELAB AMERICAS INC, 123 Ambassador Drive, Suite 123,
Naperville, IL 60540, USA
ComplianceManager@minelab.com.au
Compliance Statements for Canada (as applicable)
This product meets the applicable Innovation, Science and Economic Development
Canada technical specifications.
RSS-Gen notice: This device complies with Industry Canada’s license-exempt
RSSs.
Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Modification
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the device.
Simplified EU & UKCA Declaration of Conformity Hereby, Minelab Electronics Pty
Ltd declares that the radio equipment type [Refer to detectors listed in Table
1] complies with Directive 2014/53/ EU and The Radio Equipment Regulations
2017 (S.I. 2017 /1206). Full text of the EU & UKCA declarations of conformity
are available at the following internet address:
www.minelab.com/compliance.
EU Importer: MINELAB ELECTRONICS PTY LTD, 2 Second Avenue, Mawson Lakes, SA
5095, Australia
License / Permit
The equipment operator is responsible for investigating and obtaining any
required local license or permit for metal detecting activities.
WEEE:
****This symbol indicates that the equipment and its electrical accessories
should not be disposed of as household garbage.
These items should not be disposed of as unsorted municipal waste and should
be taken to a certified collection point for recycling and proper disposal.
Refer 2012/19/EU (Waste Electrical and Electronic Equipment).
Table 1:
RADIO FREQUENCY SPECIFICATION
Detector | Wireless Audio |
---|---|
Detector | Frequency |
VANQUISH
340/440/540| 5to143 kHz| < -30 dBm| 2A to 2.5 GHz| 0 dBm
EQUINOX 1300/800| 3.7 to 143 kHz| < -30 dBm| 2.4 to 2.5 GHz| -5.9 dBm / -0.5
dBm
CTX 3030| 1.3 to 141 kHz| < -30 dBm| 2.4 to 2.5 GHz| 14 dBm
GO-FIND Series| 7.4 to 82 kHz| < -30 dBm| 2.4 to 2.5 GFlz| 8.9 dam
Excaltur II| 1.3 to 141 kHz| < -30 dBm| —| —
Manticore| 2.5 to 143 kHz| c -30 dBm| 2.4 to 2.5 GHz| +5 dBm
I PRO-FIND 15/20/35| 11 to 13 kHz| < -30 dBm| —| —
Gold Monster 1000| 43 to 488 kHz| < -30 dBm| —| —
SOC 2300| 3.5to148kHz| < -30 dBm| —| —
GPZ 7000
GPX 5000| 1.18 to 147 kHz| < -30 dBm| 2.4 to 25 GHz| 0 dBm
1.1 to 145 kliz| < -30 dBm| —| —
GP% 6000| 1.18 kHz to 147 kHz| < -30 dBm| 2.4 to 2.5 GHz| +4 dBm
MLSO| —| —| 2A- to 2.485 GHz| +4 dBm
ML100| —| —| 2.4 to 2.5 GHz| +3 dBm
ML85| —| —| 2.4 to 2.5 GHz| +3 dem
ML105| —| —| 24 to 2.5 GHz| +3 dBm
Table 2: CERTIFICATION SCHEME ID
Detector | FCC ID | Anatel | Japan MIC | KC | ISED | NOM | BIS/ETA |
---|---|---|---|---|---|---|---|
VANQUISH 540 | Z4C-0041 | 17411-20-11695 | 001-A16239 | R-C-Tej-0041 | 24927-0041 |
ANC2101C
00019753| ETA-SD-
20210100676
VANQUISH 340/440| 03956-21-11695| R-R-Tej-0041A| ICES-3(B)/| R-41220116
EQUINOX 600/800| Z4C-0022| 04023-21-11695| 003-180034| R-CMM-TejEQUINOX800|
NMB-3(B)| ANC2101C
00019752| ETA-SD-
20210100634/636
R-41211974
CTX 3030| Z4C-1010| 16616-20-11695| —| R-R-Tej-1010| 24927-0022| ANC2101C
00019751| ETA-SD-
20210100667
GO-FIND 44/66| Z4C-2660| 17188-20-11695| 003-180016| R-CMM-Tej-GO-FIND66| —|
ANC2101C
00019753| ETA-SD-
20210100638/640
GO-FIND 11/22| —| 24927-2660| —| —
Excalibur II| sDoC| 04139-21-11695| —| R-R-Tej-0454| ICES-3(B)/ NMB-3(B)|
ANC2101C
00005942| —
Manticore*| Z4C-0049| —| —| R-R-Tej-0049| —| —| R-41206582
PRO-FIND 15/20/35| sDoC| 00108-21-11695| —| R-R-Tej-0018| 24927-0049| ANC2101C
00019754| —
Gold Monster 1000| sDoC| 06876-18-11695| —| R-R-Tej-0019| ICES-3(B)/ NMB-3(B)|
ANC2101C
00019750| R-41206482
SDC 2300| sDoC| 05531-20-11695| —| R-R-Tej-0012| ICES-3(B)/ NMB-3(B)| ANC2101C
00019750| R-41206482
GPZ 7000| Z4C-7000| 05965-18-11695| —| —| —| ANC2101C
00019751| —
GPX 5000| sDoC| 04112-21-11695| —| —| —| —| —
GPX 6000| Z4C-0039A| 03121-21-11695| —| R-R-Tej-0039| 24927-0039| ANC2101C
00019750| —
ML80| 2APN8-ML80| —| 204-B00553| R-R-Tej-ML80A| 24927-ML80A| IFT: RCPMI
3021-0175| ETA-SD-
20210100662
R-41216798
ML100| Z4C-ML100A| —| —| R-R-TejML100A| 24927-ML100A| IFT: RCPMI
3021-0175-A1| —
ML85| Z4C-ML85| —| 210-188906| R-R-Tej-ML85| 24927-ML85| —| R-41216798
ML105| Z4C-ML105| —| —| R-R-Tej-ML105| 24927-ML105| —| —
- indicates use of e-labelling; follow instructions in Manual/carton to access.
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its
subsidiaries. Qualcomm is a trademark of Qualcomm Incorporated, registered in
the United States and other countries. aptX is a trademark of Qualcomm
Technologies International, Ltd., registered in the United States and other
countries. | The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by [Minelab Electronics
Pty Ltd] is under license. Other trademarks and trade names are those of their
respective owners.
Certification and logo usage dependant on product and region
Minelab
Electronics, PO Box 35, Salisbury South, South Australia 5106
4901-0437-1
References
- MINELAB - Register Your Minelab
- Concidiones de garantía limitadas del producto Detectores de metales de alto rendimiento
- StackPath
- StackPath
- StackPath
- StackPath
- StackPath
- Product Warranty | Minelab Metal Detectors