INS GLOBAL D5 Series Smart Card and Keypad Installation Guide
- June 6, 2024
- INS GLOBAL
Table of Contents
INS GLOBAL D5 Series Smart Card and Keypad
Introduction to INS D5
Thank you for purchasing an INS D5 Series Mifare Contactless Smart Card &
Keypad Reader.
The Keypad will output Cotag 4422 format. It can be custom configured on
request
Wiring methods shall be in accordance with National Electrical Code,
ANSI/NFPA70.
Discharge the body of static electricity before wiring the unit
- Connect the 0V (GND).
- Connect the other Required cables apart from 12Vdc.
- Attach the 12Vdc wire last.
Specifications
Information contained in this document is subject to change without
notice
Warranty
The D5 Series reader comes with a 3 year warranty from the date of dispatch
from INS Global. The warranty is void if the installation instructions
contained with this manual have not been adhered to.
Any changes or modifications not approved by INS Global could void the user’s
authority to operate this equipment
DRILLING TEMPLATE
SCALE 1:1
DIMENSIONS IN MMS
Placing the reader
- Insert four (4) screws (not included) into holes
- Hook reader onto base.
- Attach reader to base with base screws (included)
General Wiring Schematic
NO TE
The 0V reference cable shall be included withing the controller cable. The
12Vdc power cable shall NOT be included in the controller cable. Only one
power source is connected to the reader at any time.
LED line is low activated
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>