Zeeva M48-ENC TWS Wireless Earphones User Manual
- June 5, 2024
- Zeeva
Table of Contents
Zeeva M48-ENC TWS Wireless Earphones
Twin Mode
-
Step 1
Take two earbuds out of the package -
Step 2
Put two earbuds in the charging case, and charge the case 30 minutes, then go to step 3 -
Step 3
Open the charging case, the earbuds will flash blue light slowly after 3-5 seconds (if always flash blue and red light. please double click the Right earbuds, wait until its flash blue light slowly. -
Step 4
Turn on the Bluetooth on device and search “M48-ENC” to connect
Single Mode/ Functions
-
Step 1
Take out any one of the earbuds from charging case -
Step 2
Tum on the Bluetooth on device arid search M-48-ENC to connect Remark the earbuds will be connected automatically with mobile if it has been connected before
Long Press
- Long press Reject call
- Long press 4s Power on/off
Short Press
Charge
NOTE:
Please use the original charging cable. Fast charging are prohibited.
if any of the following conditions occur while using this product, it can be resolved independently,
-
Left&Right earbuds can not pairing with each other Take out the earbuds from charging case, two earbuds always flash red and blue or there are two Bluetooth name of M48-ENC on the mobile
Solution: Turn off both earbuds, delete the connection record M48-ENC displayed in the connection list of the phone or other Bluetooth devices. Then 2 click the right earbud quickly, after 2-3s, both earbuds will flash blue slowly, that means they have paired with each other successfully -
Only one earbud working
When connected the mobile, on ly one earbud working, and the other one flashes red and blue light or no light flashes.
Solution: Turn off both earbuds, delete the connection record M48-ENC displayed in the connection list of the phone or other Bluetooth devices. Then 2 click the right earbud quickly, after 2-3s, both earbuds will flash blue slowly, that means they have paired with each other successfully. -
Earbuds can not be connected with mobile Solution:
-
Turn off the earbuds and turn off the Bluetooth on molile, then turn on earbuds andturn on Bluetooth on molile, to search the Bluetooth name M48-ENC again.
-
If the earbuds has been connected by the module before, then just need to find the Bluetooth name in the Bluetooth list, and connected.
-
Delete the Bluetooth list record on mobile, then search M48-ENC to connect
FCC Statment
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur
in a particular installation.If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC ID: 2ADM5-MA-3050
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>