bol Connecting The Remote Control To Your Lights App Installation Guide

Connecting the remote control to your Lights.

STEP 1: Put battery inside the remote Make sure it’s workable
STEP 2: Turn on the light
STEP 3: Press the “ON 1” button within 3 seconds after turning the light on

Connecting the APP to your Lights.

STEP 1: Download the app by scanning the QR Code, and installing it on the phone

http://www.jasonghost.com/lampsmartpro/

STEP 2: Turn on the light

STEP 3: Open the Bluetooth and click this button to search the light, and follow the instruction to finish the pairing between the phone and light.

Installation steps

1. Open the box and take out the parts
2. Get every part unpacked and start to assemble.
3. Assemble the short tubes to petals the short end of the tube goes into the petal.
4. Assemble the long tubes to the rest petal, the short end of the tubes will be twisted into the petal as well.
5. Assemble the petals with long tubes to the plate
6. Fix the petals to the plate with nuts.
7. Assemble all the 3 petals with short tubes to the plate as shown.
8. Assemble the petal with short tubes to the corner of the plate.
9. Fasten the petal with nuts.
10. Use a wrench to tighten up the nuts further.
11. Connect all the wires to the collector plate as shown.
12. Install the screws with flat heads to the cross, use the small nuts to settle the position of each screw.
13. Put down the cross, find out the four small holes on the plate, make sure all the screws installed on the cross can go through the holes on the plate.
14. Install the cross with the sharp point screws to the ceiling, do not move the four flat-headed screws
15. Life up the light and install it to the cross, the four flat-headed screws go through the plate and then use the nuts to fasten the light.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>