Sunday Living PTC-1503D-NO2-1 Ceramic Tower Heater User Manual

CERAMIC TOWER HEATER
MODEL.: PTC-1503D-NO2-1

WARNING

Thank you for purchasing your new heater.
These operating instructions will help you use it properly and safely.
We recommend that you spend some time reading this instruction manual in order that you fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction manual for future reference
Facebook: #SundayLiving
Message: #SundayLiving
Email: service@sundaylivinginc.com

INTENDED USE

• This product is intended for indoor residential and office use only, not for industrial or other commercial applications.
• Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances.
• This heater must be plugged into a 120V AC circuit.
• Do not plug anything additional into the same circuit. If you have any questions about whether your wiring is adequate, consult a qualified electrician. Risk of fire, overheating, malfunction, property damage, injury, or even death result if not adhered to.
• Use your heater only with a working smoke detector located in the vicinity of your heater.
• While using your heater, you should follow the IMPORTANT INSTRUCTIONS listed below. As part of those instructions, we have used the word “WARNING” to indicate the level of a hazard: WARNING indicates a hazard that, if not avoided, could result in injury or death.

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

• Read all the instructions before using this heater.

• This heater/fan is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use provided handle when oving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 0.9 meters from the front of the heater-fan and keep them away from the sides and rear.

• Do not use heater unattended. Use of extreme caution is necessary when any heater is used by or near children, invalids, disabled persons, or pets.

• Do not operate the heater with a damaged power cord or after the heater malfunctions, has been dropped, or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.

• Do not use a heater outdoors.

• Use your heater only in dry environments. This heater is not intended for use in a bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate a heater where it may fall into a bathtub or other water container. Do not use in damp environments such as flooded basements.

• Do not place the heater on a small, unlevel, uneven or any surface that might allow the heater to tip or fall.

• For proper operation, the heater should be placed on a smooth, non-combustible surface.
  Do not place on rugs, carpet, vinyl flooring or other plastic surfaces. Not for use outdoors or in wet areas.

• This heater is not designed as a primary heat source.

• Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable power tap (outlet/power strip).

• Always unplug the heater when not in use.

• Do not run power cord under carpeting. Do not cover the cord with throw rugs, runners or similar coverings. Arrange cord away from traffic area where it will not be tripped over.

• To disconnect the heater, turn controls off then remove the plug from the outlet.

• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater.

• To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces like a bed, where openings may become blocked.

• A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.

• Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons or property.

SAFETY FEATURES

Tip-Over Safety Feature
This heater is equipped with a shut-off safety feature. Once the heater is tipped over, an
internal switch will automatically shut the heater off. Once the heater is restored to an
upright position, the heater will reset and you can open heating again.
Overheat Safety Feature
This heater is equipped with an overheat safety feature. When the heater’s internal
components reach a certain temperature that could cause overheating and possible fire the heater will automatically shut off.

• A thermal overload protector is built in to prevent overheating. When an “overheat” temperature is reached, the heater will automatically shut off. The operation can resume only when the user resets the unit.
• To reset the unit, unplug the heater, ensure the power is turned off, and wait for 15 to 2minutes for the unit to cool down.
• Follow INSTRUCTIONS FOR USE to return the heater to operating mode.

FUNCTION INTRODUCTION

1. Standby mode
   Plugin the power, turn on the power switch, the display screen shows the ambient temperature, the product standby.

2. ON/OFF button
   Press ON/OFF button for the first time, the product will be powered on and the air supply indicator will light up. Press the ON/OFF button again in the unheated state. Directly to turn it off. In the reheating state, press the ON/OFF button, the product will continue to supply air for 30 seconds after shutdown.

3. Heating Mode
   After pressing the “ON/OFF” once, the indicator light shows , it means Fan only.
   Press the heating button, there are two heating settings for you to choose.
   Press once, the indicator light shows , now is Low Heating.
   Press again, the indicator light show , now is High Heating.
   Press third time, the Heating function is off.

4. Temperature setting
   Press the temp setting button , by default, the first time you press the thermostat button, it will show 75 Fahrenheit degrees, the temperature setting starts at 75 Fahrenheit degrees.
   The temperature can set between 60-95 degrees Fahrenheit. Under any working conditions, then press the temperature button, is to reset the temperature, temperature display with the original set temperature value as the first display. Under the working the environment of temperature setting, press the to cancel the temperature setting, the product stops heating, and there is only air supply function.

5. Timer setting
   In the power-on state (the product is working), press the timing button on the control panel or remote control to turn on the timing function. After setting the time, the machine will shut down at the set time.(Press the timing button to turn on the timing function, increase from 1 hour to 12hours, after reaching 12 hours, press again to turn into 0 hours)

6. Oscillation setting
   Press the oscillation setting button , the heater will start to swing from side to side.

7. Safe child lock
   In the standby working state or the working state, long-press the temperature and timer button for three seconds at the same time, it can be locked, no light can be lit, single press all the keys invalid. At the same time, a long press for three seconds can also unlock, no light can be turned off. Long press the rotary key for three seconds to turn off the screen or turn off the light, and press any key to wake up. After power on again, the above should be pressed again.

REMOTE

NOTE: Please feel free to contact Service Team for help if the remote control is missing or damaged.
Facebook: #SundayLiving
Message: #SundayLiving
Email: service@sundaylivinginc.com

1. POWER
   Switches on me off the heater or stand by

2. Heating Mode
   Press the heating button, there are 1000/1500W heating settings for you to choose from.

3. Temperature Setting
   The temperature can set between 60-95 degrees Fahrenheit.

4. Oscillation Setting
   Press the oscillation setting button, the heater will start to swing from side to side.

5. 12H Timer
   Press the timing button to turn on the timing function, increase from 1 hour to 12 hours ;

6. Safe Child Lock
   The control panel or remote can be locked, single press all the keys invalid, until press it again to wake up.

STORAGE

1. Save the original box for off-season storage.
2. Clear the heater with a soft, damp cloth.
3. Place the Radiator and Base Feet in the original box, and store in a cool and dry place.
4. Ensure the heater is covered to protect from dust.

MAINTENANCE & CLEANING

1. Turn off the POWER.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. A mild detergent can be used if necessary.
4. After cleaning, dry the unit with a soft cloth.
5. Wait until the unit is completely dry before use.

WARNING

• DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater.
• DO NOT immerse the heater in water.

TROUBLESHOOTING

If the heater will not operate, please check the following:

1. Check if the power cord is plugged into an electrical outlet. If not, plug-in unit to appropriate outlet.
2. Ensure the POWER is on.
3. Make sure the heater is placed on a flat solid surface.
4. Check for obstructions at the intake and exhaust vents.

• If obstructions are present, refer to the instructions for resetting your heater when the Overheat Protection System has been activated.
• If no obstructions are present, and your heater still does not operate normally, turn the POWER SWITCH to the “OFF” position, disconnect the power cord from the electrical outlet, and consult an authorized repair technician.

Email: service@sundaylivinginc.com
Facebook: #SundayLiving

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>