TELOX TE620 Smart LTE Handheld User Guide
- June 6, 2024
- TELOX
Table of Contents
TE620
Quick Start Guide
Thanks for choosing our product!
This Quick Start Guide is only applicable to TE620.
Before using the product, please read the Quick Start Guide to fully benefit
from it.
| Operating State | Indication |
|---|---|
| Low Battery | Red(Blinking) |
| Charging | Red(Steady) |
| Fully Charged | Green(Steady) |
| PTT Transmitting | Red(Steady) |
| PTT Receiving | Green(Steady) |
| --- | --- |
Note
- The warranty period is 1 year from the date of purchase.
- This product involves constant upgrading and/or improvement, our company reserves the right to change the specifications of software and/or hardware mentioned in this operating guide without any prior notice. The product specifications and infor mation mentioned in the operating guide are for reference only.
CHECKLIST
Notice:
Please check the above accessories before you discard the packing material.
Please contact your local dealer immediately if there is any missing or
damaged parts.
BEFORE USE
| 1. Insert the SIM/TF card into its slot. Attach the SIM cover and tighten
the set screw. (For Dual-SIM device, SIM card can be inserted in SIM 1 or SIM
2, or two cards for both, Dual-SIM device doesn’t support SD card.)
---|---
| 2. Put the battery into the compartment, then put on the cover and lock.
| 3. Press and hold the power button until the screen lights up to turn on
the device. Press the power button to put the device screen to sleep, press
again to wake it up.
charging
Connect the LTE handheld and power adapter using the USB Data Cable.
The red light on the LTE handheld indicates battery charging is in progress.
Green lights on indicating fully charged.
Notice:
Always use Telex Original batteries and chargers. The warranty does not cover
damage caused by nonTelex batteries and/or chargers.
Caution
- Although your device is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting or bending, or sitting on it.
- Make sure the charger/USB port, microSD card/SIM card slot covers are properly seated, with no foreign objects obstructing the seals.
- Do not use the charger/USB port for charging, data transmission, etc. until the phone is completely dry.
- Do not store the device under any circumstance containing electronic erosive material.
- Avoid pulling the device up by holding the antenna or accessories• Please power off and unload the battery before cleaning the device.
- Using dry and clean lintfree cloth or hairbrush to keep the device and charger docking port clean.
- Avoid using any chemical agent including detergent, alcohol, aerosol spray, or oil preparations as a cleaning solution.
- Dry your device completely after cleaning and before using it again.
FCC Statement
15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
15.21 Information to the user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This product meets the government’s requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluations of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health. FCC RF
Exposure Information and Statement The SAR limit of the USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. This device was tested for typical bodyworn
operations when the device was used at 25mm from the front face and 10mm from
the product, 0mm from the belt, to maintain compliance with FCC RF exposure
requirements. The use of belt clips, holsters, and similar accessories should
not contain metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with FCC RF exposure
requirements and should be avoided.
CE Warning
- Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
- The product shall only be connected to a USB interface of version USB2.0 or higher.
- The adapter shall be installed near the equipment and shall be easily accessible.
- The operating temperature of the device can’t exceed 40C and shouldn’t be lower than 20C.
- The plug is considered as a disconnect device of the adapter.
- The device complies with RF specifications when the device is used at 5mm from the body without beltclips, 0mm from the body with the beltclips, 25mm from the face.
- The band 51505350MHz indoor use only.
Hereby, Te/ox Communications Co., Limited declares that this Mobile phone product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.
Telex Communications
Tel:+8675586950766
Email:sales@telox.com
Add:6/F, No.42 Liuxian 1st Road, Baoan District, Shenzhen, China
www.telox.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>