G PEN Elite II Vaporizer User Guide
- June 6, 2024
- G PEN
Table of Contents
G PEN Elite II Vaporizer User Guide
QUICK START GUIDE
-
Register SN number at bottom of device or packaging at GPen.com/Register.
-
Fully charge device using included USB to USB-C Charging Cable.
-
Remove mouthpiece and load chamber. Re-attach mouthpiece.
-
Press and hold power button for three seconds to power \ on/off device.
-
Use + and – buttons to set ‘ desired temperature.
-
Double-dick power button to begin/cancel heat session.
-
Press power button five times to access device Settings Menu.
-
Press + and – buttons to navigate menu. Press power •t\i~✓ button to select: Brightness, Haptic Feedback, F0 / C0 , Firmware.
-
Access pick tool at bottom of device for packing, stirring, and cleaning .
The device supports 2.4G WiFi function.
FCC warning:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to
correct the interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
The device has been evaluated to meet general RF exposure requirement..
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>