Wingo Times Shenzhen Group K1 3 in 1 Wireless Charging Station User Manual
- June 6, 2024
- Wingo Times Shenzhen Group
Table of Contents
K1
3 in 1 Wireless Charging Station
User Manual
Only use certified 18W 9V/2A adapter
Product Description
This product is a set of mobile phones, earphones, watch in one of the three in one wireless charger, It uses a folding position to charge the earphones, while the watch can be charged by sliding cover and push-pull mode, It also supports horizontal and vertical charging design is small and beautiful, especially suitable for home office use.
Product Usage
One end of the TPYE-C data line is inserted into the input port of the product, and the other end is connected to the charging head so that the product can be used normally.
Function Introduction
- Standby: power on the product, double green lights flash out, in the standby state
- Earphone charging: Open the folded lower shell and lay it flat, place the earphone that supports wireless charging in the center of the charging sign, the green light on the product will be turned off after 20 seconds and then the earphone charging indicator will be on until it is fully charged.
- Watch charging: Slide right out of the top cover, then place the watch that supports wireless charging in the center of the charging sign mark automatically adsorption, watch shows charging.
- Mobile phone charging: Open the mobile phone bracket, the mobile phone that supports wireless charging can be placed horizontally or vertically on the bracket, the green light under the product will be on for 20 seconds, and the mobile phone will display charging instructions until it is fully charged.
Electrical Parameters
| Input voltage | 9V/2A, 12V/2A |
|---|---|
| Output power | 15W,5W,3W |
| Interface | Type – c |
Support QC and PD protocol
Announcements
- This product need uses the recommended adapter
- Avoid violent impact and falling.
- Do not place it in direct sunlight, high temperature, and damp place.
- Avoid using liquid or hard cloth with corrosive chemical composition to wipe the surface of the product.
90*60mm
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF warning for WPT device:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of the device, a distance of
15cm surrounding the device and 20 cm above the top surface of the device must
be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>