iLIVE ISBW108 Waterproof Wireless Speaker User Guide
- June 6, 2024
- iLive
Table of Contents
iLIVE ISBW108 Waterproof Wireless Speaker
Previously Connected Devices
- The speaker can remember multiple Bluetooth devices and will always try to reconnect to the last device used.
- Bluetooth on unwanted devices, then access the Bluetooth settings menu on the device you wish to use and select ISBW108.
- If the speaker should become unpaired or will not connect normally, follow these steps in your device’s Bluetooth Settings Menu.
» Delete the speaker (“Forget This Device”).
» Turn Bluetooth OFF then ON again, and repeat the Initial Bluetooth Connection.
Aux In (3.5mm Audio Input)
- Connect a 3.5mm audio cable (not included) to the Aux In on the unit and the audio output/headphone jack on a media player.
- The unit will automatically detect the input and switch to Aux In Mode, indicated by a voice prompt and a slowly blinking indicator light. Use the controls on the connected device to select and play audio.
FCC WARNINGS
This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could
lose the authority to operate this equipment if an unauthorized change or
modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. The device has been
evaluated to meet general RF exposure requirements. The device can be used in
portable exposure conditions without restriction.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- The rating information is located at the bottom of the unit.
ADDITIONAL WARNINGS
WARNING: Where the mains plug or appliance coupler is used as the
disconnect device, such disconnect device shall remain readily operable.
Lithium batteries, like all rechargeable batteries, are recyclable and should
be recycled or disposed of according to state and local guidelines. They
should never be disposed of in normal household waste and they should never be
incinerated, as they might explode. Contact your local government for disposal
or recycling practices in your area.
To avoid hearing damage, make sure that the volume on your music player is
turned down before connecting your earbuds or headphones. After placing
earbuds in/on your ears, gradually turn up the volume until you reach a
comfortable listening level.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings. ca.gov. This product meets and complies with required Federal product guidelines
Features
- Bluetooth wireless: range 60 ft.
- Durable fabric & rubberized coating
- DC battery power – built-in rechargeable battery: approx. 7.5 hrs playtime at 50% volume
Includes
- USB charging cable
- Carabiner
- User’s Guide
Waterproof Rating – IPX5
- Protection from contact with enclosed equipment.
- Protection from heavy splashing water.
- Protection from dust, oil, and other non-corrosive material.
IMPORTANT: To ensure your speaker is prepared for use in a wet environment, disconnect and remove any power cables, and tightly close the charging port water cap. If the water cap is not properly closed, water resistance will be compromised and could result in damage to the speaker or personal injury.
Overview
Charging the Battery
Warning: Do not charge the speaker while it is in or near water. If
splashed or wet, allow ample time to dry before charging.
Initial charge time is approximately 2 hours. Charge fully before use.
Pull back the water cap and use a Micro-USB to USB cable (included), to connect to the USB port of a powered on computer or USB power adapter (not included).
P o w er S ta tus| I ndic a t
or Ligh t
---|---
_Low Battery| Flashing red light_
_Charging| Solid Red light_
Finished Charging| No light
Pairing & Playing Audio
When first powered on, the speaker defaults to Bluetooth Mode, indicated by a voice prompt. All other play modes will change automatically when connected to the different audio sources.
- Power on the speaker by pressing and holding the Power button. When first powering on, the unit will start in Bluetooth Mode, indicated by a voice prompt. When pairing, remain within 3 feet of the unit.
- Using the controls on your Bluetooth device, select ISBW108 in the Bluetooth Settings to pair. If need be, refer to the user’s manual for your specific device for more information.
- When successfully paired, a voice will announce “Bluetooth is connected” and the LED indicator will turn solid blue. Audio from the connected Bluetooth device will now be heard through the speaker.
- Use the controls on the connected Bluetooth device to select and play audio. Use the speaker controls or the connected Bluetooth device to play, pause, and adjust the volume level.
- After initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a reset of the device. Note: If your device should become unpaired or you find it is unable to connect, press & hold the button to enter into Pairing Mode. A voice will announce “Bluetooth is connecting” and you can connect to the speaker manually
Using the Speakerphone
- To accept a call, press the phone button or use the controls on the connected phone.
- To end a call, press the phone on the connected phone.
- To re-dial, the last dialed number, press the phone button twice.
Contact Information
Website: www.iLiveElectronics.com
Email Support: prodinfo@dpiinc.com
Email Parts: partsinfo@dpiinc.com
Phone Support: 1-888-999-4215
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>