motorola MOTO BUDS 250 In-Ear True Wireless Earbuds User Guide
- June 6, 2024
- Motorola
Table of Contents
Quick Start Guide
- Model No.: MOTO BUDS 250
- Frequency Band: 2.402 – 2.480GHz
|
- Maximum RF power: 6 dBm
- FCC ID: 2ARRB-MB250
|
- IC: 20353-MB250
- Working temperature: -10°C–45°C
---|---|---
Charging:
Fully charge before use
The device can be powered through a USB-C from any CE compliant power source
that implement the European interface as requested by EN 301 489-52.
Pairing:
-
Ensure both buds are inside the charging case and take out both buds. The buds will flash blue and red.
-
Select “MOTO BUDS 250″ from the smartphone bluetooth menu.
Fitting:
-
To optimize the best fit and audio experience, it is recommended to try different earbud sizes.
-
Insert the MOTO BUDS into your ear and rotate to fit comfortably.
Basic Operation:
Additional Operation
Additional Operation | MFB 2sec |
---|---|
Receive incoming and on hold ongoing call | Single Press MFB |
LED Indicator
Pairing| Red-blue flash
Standby| Blue flash
Charging| Red steady
Fully charged| Off
Battery low| Red flash
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device. The term “IC: “ before the certification/registration number only signifies that the Industry Canada technical specifications were met. This product meets the applicable Industry Canada technical specifications.
FCC and IC regulations (FCC Part 15)
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the Federal
Communications Commission (FCC) rules.
Industry Canada. This device complies with Industry Canada licenceexempt RSS standard(s): Operation is subject to the following Two conditions:(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Disposal of the Device (environment)
At the end of the product life cycle, you should not dispose of this product
with normal household waste. Take this product to a collection point for the
recycling of electrical and electronic equipment. The symbol on the product,
user’s guide and/ or box indicates this. Some of the product materials can be
re-used if you take them to a recycling point. By reusing some parts or raw
materials from used products you make an important contribution to the
protection of the environment. Please contact your local authorities in case
you need more information on the collection points in your area.
European Union Directives Conformance Statement The following CE compliance information is applicable to Motorola products that carry one of the following CE marks: Hereby, MZGW declares that this product is in compliance with:
- The essential requirements and other relevant provisions of RED Directive 2014/53/EU
- All other relevant EU Directives
- The Declaration of Conformity can be obtained at motorolasound.com
UK Declaration of Conformity
Hereby, MZGW declares that this product is in compliance with the requirements
for UKCA marking. The Declaration of Conformity can be obtained at
motorolasound.com
Imported and distributed by: A.I.&E., Adriaan Mulderweg 9-11, 5657 EM Eindhoven, The Netherlands. Edco UK Ltd, 1st Floor, Two Chamberlain Square, Birmingham, B3 3AX, UK.
Global V4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>