XTREME XWC8-1022-BLK 10W Fast Wireless Charger at Menards User Manual
- June 6, 2024
- Xtreme
Table of Contents
XTREME XWC8-1022-BLK 10W Fast Wireless Charger at Menards
XWC8-1022-BLK
Package Contents
- 10W Wireless Charger
- 3ft Micro USB Power Cable
- Manual
PRODUCT INTRODUCTION
The Xtreme 10W Fast Wireless Charger is an intelligent product with a compact design which is compatible with iOS and Android smartphones with wireless charging capabilities.
APPLICABLE DEVICES
Any iOS or Android smartphone that is Qi standard will operate with the
wireless charger. For maximum 10W charging, an 18W QC 3.0 orPD USB home
charger is required (not included).
Note: iOS devices are limited to 7.5W
OPERATING INSTRUCTIONS
-
Insert the USB end of the power cable into a USB power adapter (not included) as shown below.
-
Insert the micro USB end of the power cable into the micro USB port on the wireless charger. The LED indicator will flash blue three times to indicate power connectivity.
-
Place your smartphone device onto the center of the wireless charger. The smart LED indicator will illuminate blue to indicate that the device is charging. For Android devices, the LED indicator will turn off when the device is fully charged. For iPhone devices the LED will remain blue.
SAFETY AND CARE INSTRUCTIONS
Failure to follow these safety instructions can lead to fire, electrical shock, personal injury, property damage or damage to this unit. Make sure to read this entire manual before initial use.
- Do not use this unit for anything other than its intended use.
- Keep the unit away from heat sources and direct sunlight.
- Do not expose the unit to extremely high or low temperatures.
- Use the product in a location with a temperature of 32°F – 95°F.
- Do not let the unit come in contact with water or any liquid. If it becomes wet, immediately unplug from the power source.
- Do not handle the unit, USB cord, or wall charger with wet hands.
- Do not let dust or other debris accumulate on the product and the wall charger.
- Do not use the unit if it has been dropped or damaged in any way.
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
- If you have an electrical device, such as a pacemaker, consult a physician before using this product.
- Do not place magnetic cards or similar items near this product.
- Be sure to use the specified power source and voltage.
- Do not use a voltage converter/travel adapter.
- Be sure the wall charger is inserted all the way into the electrical outlet. When not in use, unplug the wall ch,arger.
- Place the unit on a flat, sturdy surface during charging.
- Keep the unit out of reach of children as this product is not a toy
FCC CAUTION
Any changes or modifications not expressly approved by the part responsible
for compliance could void this user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two co nditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there 1s no guarantee that interference will not occur in a
particular installation. If this equipment does not cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to corre,ct interference
oy one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RADIATION EXPOSURE STATEMENT:
This equi ment complies with FCC radiation exposure limits set forth for an uncontrolled enrolled environemnt. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CAUTION :
To prevent damage to the phone or the charger:
Remove metal cases, or cases with any magnet/metal components, from phone
before charging.
Do not place metal objects on the charger during charging.
NOTE:
Qi wireless chargeable phones with metallic looking finishes will charge
normally. Very thick protective cases can obstruct charging. For effective
charging it may be necessary to reposition the phone or remove the case.
ONE YEAR WARRANTY
Xtreme warrants its products for ONE YEAR against defects in manufacturing under regular consumer use with original receipt of retail purchase.
We believe in our products and want to provide you with a replacement, if needed, but we have to know about the problem while the product is still under warranty. If you discover a defect covered by this warranty, please contact us about receiving a replacement. In order to use the products warranty the customer must provide proof of the retailers receipt.
* Any customers outside of the U.S. will be responsible for shipping and handling charges if a replacement is required that is not due to a manufacturing defect. If there is not a manufacturing defect, shipping and handling will be applied.
Xtreme’s warranty is limited to our products only. Our warranty does not cover the replacement or repair cost of any third-party accessory, electronic device or personal property.
For instructions about how to obtain warranty service for your product, please
contact Customer Service at
customerservice@xtremecables.com
SPECIFICATIONS
Input: Micro USB 5V~ 2A, 9V ~ 1.67 A
Output Power: SW /1 OW (SV ~ 1 A, 9V ~ 1.1 A)
Size: 3.9″ diameter x 0.5”
FCC ID: 2AHAS-XWC81022H
SSS-999-8041 |www.xtremecables.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>