FEIT Electric BTA60RGB3KESM RGBW Speaker Bulb Instructions
- June 6, 2024
- Feit Electric
Table of Contents
Single Bulb Pairing Instructions
1. Power on the bulb. The bulb will sound a chime when available to pair.
2. Using a compatible Bluetooth device, search for the bulb “ RGBW Speaker Bulb “.
3. Connect, wait for the chime that signifies successful pairing, and play music.
Two Bulb Pairing Instructions (TWS)
1. Power on two bulbs at the same time. Both bulbs will sound a chime when available to pair.
2. Wait until the bulbs automatically connect to each other. One will become the primary and the other will become the secondary. The secondary bulb will sound a chime once complete, indicating that it is successfully connected to the primary bulb.
Primary Secondary
3. Using a compatible Bluetooth device, search for the primary bulb “ RGBW Speaker Bulb “.
4. Connect to the primary bulb, wait for the chime that signifies successful pairing, and play music.
Remote Operation
-
Audio On/Off:
Turns the audio On or Off -
Light On/Off
Turns the light On or Off -
White Light Dimmer:
Press to choose between brightness levels of white light -
Color Light Cycling:
Press to continuously cycle through all six colors: Red, Green, Blue, Magenta, Cyan, Yellow -
Color Light Solid:
Press to select one of the six color options
Resetting Bulb to Color Light Cycling
If the remote is lost or not working properly, reset the bulb to color light cycling by flipping the wall switch three times.
CAUTION:
This device is not intended for use with emergency exits. Only use the control
provided with or specified by these instructions to control this lamp. This
lamp will not operate properly when connected to a standard dimmer or dimming
control.
Federal Communications Commission (FCC) Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement: For Light (Model No.:BTOM60RGB3KESM)
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
FCC Radiation Exposure Statement: For remote control (BTOM60RGB3KESM/REM)
This equipment complies with FCC radiation exposure requirement. The device
can be used in portable exposure condition without RF striction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>