LUCKY BOY 138258 RC Car User Manual
- June 6, 2024
- LUCKY BOY
Table of Contents
USE MANUAL
PARTS IDENTIFICATION
R/C CAR INSTRUCITON
CHARGE INSTRUCTION
- Plug the charging cable into the Lithium Cell.
- Plug the USB cable into a 5V power source (e.g. PC, phone charger, power bank) with maximum 2A output.
Charging should take between about 100 minutes depending on how much charge is left in the battery.
NOTE: Do not charge the battery immediately after use.Let’s the battery cool for at least 10 minutes.
The charging indicator will light up when Charging and it will turn off when it is fully charged.
BATTERY INSTALLATION
- Open the battery cover.
- Install 2×1.5V AAA batteries(not included) in the correct positive (+) and negative (-) polarities direction.
- Close the battery cover.
DRIVING OPERATION
NOTE
- Keep the car away from water or other liquid.
- Please play the car on clean flat surfaces.
- Adult supervision recommended at all times.
- Remove all batteries when not using it for a long period of time.
TROUBLESHOOTING
PROBLEM | SOLUTION |
---|---|
The wheels cannot turn | 1. Power switch is off please turn on. |
2. Battery exhausted, please charge.
3. Re-frequency.
Suddenly stopped during operation| 1. Check if the battery is electrical.
2. Replace or recharge the battery.
Remote control power Indicator flashes| Replace the battery.
R/C car becomes slow| Replace or recharge the battery.
ADULT SUPERVISION RECOMMENDED!
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>