FEIT Electric BPDIMSMART/2 WiFi Smart Dimmer Installation Guide
- June 6, 2024
- Feit Electric
Table of Contents
BPDIMSMART/2 WiFi Smart Dimmer
NN
NN
Technical Requirements
160g 60g writing paper, double side single black color printing; 2,110x58mm
Fold in half and halfsize:110x58mm; 3±0.5mm Tolerance ±0.5mm 4.ROHS9462EC The
material complies with RoHS requirements.
2021-07-21
60g
SD06E
JXY2.938.100S.212 A0
Caution:
This device complies with Part 15 of the FCC rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications or change to this equipment. Such modifications or
change could void the user’s authority to operate the equipment. This radio
transmitter (identify the device by certification number or model number if
Category II) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types
not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: — Reorient or relocate the receiving antenna. —
Increase the separation between the equipment and receiver. — Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. — Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC’s RF exposure guidelines, this equipment
should be installed and operated with a minimum distance of 20cm between the
radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>