emist EPIX360 TruElectrostatic Sprayer User Guide

: June 6, 2024
: emist

Table of Contents

Step 1: Installing and Removing the Battery
Step 2: Liquid Tank Install and Removal
Step 3: Removing and Installing Tank Cap and Cover
Step 4: Pouring Solution into the Tank
Step 5: Depress the Trigger Button to Begin Spraying
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Made for life. Built to work.
A MasVida Health Company
EPIX360 TruElectrostatic Sprayer
User Guide emist EPIX360 TruElectrostatic Sprayer

CONTENTS: After unpacking, inspect the components for any damage or missing hardware pieces, etc. The following components are included with your purchase:

emist EPIX360 TruElectrostatic Sprayer - figure 1

Tru Electrostatic™ Sprayer
14.4v Rechargeable Battery (2)
14.4v Battery Charger
Tank (includes the Tank, Tank liner with Cap Washer, Tank Cap with Filter, & Tank Cap Cover)
Tank Liner (4 extras included)

Step 1: Installing and Removing the Battery

For best results, make sure the battery is fully charged.
To check charge, press down on the battery indicator light, the indicator will illuminate 3 green bars when the battery is fully charged.
To install, slide the battery pack onto the bottom of the EPIX360™ handle until the battery pack is firmly seated.
To remove, grasp battery pack firmly, depress battery pack button-down, and slide out from the EPIX360™ USB power source.

Step 2: Liquid Tank Install and Removal

For the initial setup/test, remove the liquid tank from the sprayer by holding the tank cap cover and the tank, gently rocking it side to side while pulling upwards (A).
To install the liquid tank into the sprayer, align the tank nozzle to the port on the body of the sprayer and gently press the tank until you feel or hear a click as the
Tank Lock and Back Clip will engage.

emist EPIX360 TruElectrostatic Sprayer - figure 3

Step 3: Removing and Installing Tank Cap and Cover

With the tank removed from the system and holding it vertically, pull the tank cap cover straight up (B). No twisting is required (twisting will cause damage to the tank cap cover).
To remove the tank cap, gently twist counterclockwise.
To install the tank cap, gently twist clockwise, until the cap no longer turns. Each cap has a stopper that keeps you from overturning it.
To install the tank cap cover onto the tank cap, simply line the cover-up with the opening of the tank cap.

Step 4: Pouring Solution into the Tank

Once the tank cap and cover are removed, simply pour the diluted or ready-to-use solution into the already prepared tank and liner.
Note: A liner will last for 100 hours of use time or up to 3 months.

Step 5: Depress the Trigger Button to Begin Spraying

Once the system has been filled with a solution, you can begin spraying. Depress the trigger button, keeping it held down for the entire spray time desired.
Once the trigger is released, the system will turn off.
The red indicator light at the back of the system is the power indicator light. This turns on when you start spraying and will turn off when the button is released. This light indicates the high voltage power supply is charging the liquid droplets.

133 Nursery Lane | Fort Worth, Texas 76114 | 888.534.7001 |Emist.com
Copyright ©2021 EMist, a MasVida Health Company. All rights reserved.
All product names, logos, and brands are the property of their respective owners. Prices are in U.S. Dollars.
Prices are subject to change. All use of the website and resources is subject to the Terms of Use. EMI-033-21-EPIX360 Multilingual QSG – 110321